can someone please help with my starview problem

[simon_mcr]

can anyone please please help i purchased a starview box from ebay and installed it today i uploaded the flash fine and scanned the channels it picked them all up on ex c&w. i've tryed both set's of keys in the C&W section on the menu but all it keeps saying is data being updated . i really hope you can help.

thanks

simon

[kevin_molyneux]

Starview box manual key input
Entering keys manualy works fine.
Works with all firmware except 258 as known to have issue's with getting secret menu up
also no need to scan/reset just follow instructions below
To put keys in manualy do as follows.
press menu
press 1570. this takes you into secret menu
Hit ok on nagravision
and change both keys 00, and key 01
Make sure your cable provider is listed at top NTL or TELEWEST C&W
To change between the 2 keys
highlight key number press right and left
When changed hit ok (To store) after each one..

(YOU MUST SAVE EACH KEY INDIVIDUALLY - I.E. AFTER CHANGING KEY 00 MAKE SURE
YOU STORE BEFORE CHANGING KEY 01 (TO STORE PRESS OK)

EX CW- [01/06/2007]
key 00 = C8 46 5C DD 7D 18 26 3B or 1F EE 87 F9 E3 FA 2A AB
key 01 = 5B 36 AE 71 F5 21 D1 3D or 8C EF 04 6D AC 0A 8F D8

If done full factory reset/scan dont forget to turn on EMU
>> DO NOT PRESS SET DEFAULT KEY OR WILL RESET KEY CHANGE ABOVE <<
Now exit and all channels ok
On the starview remote:
Pause button = Letter A
Audio button(next to pause!) = B
Red(sub) button = C
Green(next to Red!) = D
Yellow = E
Blue = F
To enter numbers use the numbers on the remote 0-9.
To move left or right use the navigation buttons left and right.
To confirm press ok.

[simon_mcr]

cheers mate worked a treat must i had a different key