sam 2100c with ld20 ld30 problem

[adjbeatbox]

I have gotten the bk and ird through bke2.2 and saved all the files as instructed in all the tutorials on the forums.I then have written my funcard 2 and inserted it after clearing the nvram and setting the box to my frq (755.00) and pin. When I insert the card it restarts the box as per what should happen, but the box now stays at LD:20 and then goes to LD:30 and back and forth.I have left it to autoupd8 for over an hour now but its still doing the same!
I have also tried diff methods of saving the int &ext EEprom settings, and the flash.
Has anyone had this problem b4? Im getting ready to have a nervous breakdown here!!!

[steve07951]

are you trying to set the net id and pin

[edds]

Originally Posted by steve07951

are you trying to set the net id and pin

Sounds like it Steve doesn't it?

But seeing as it's been set for a pure area, indicative of 755.000. I suggest starting again, with no need to alter frequency, unless you have problems on 643.000.

Power it up after shorting, freq will go to 643.000 that's OK, just ensure netid has autoset, set PIN and do a warm boot from within eng menu. It may take over an hour for it to stop ld20/ld30'ing [sic]

[barry22]

also mate could it be a signal problem

[ronster]

Originally Posted by adjbeatbox

I have gotten the bk and ird through bke2.2 and saved all the files as instructed in all the tutorials on the forums.I then have written my funcard 2 and inserted it after clearing the nvram and setting the box to my frq (755.00) and pin. When I insert the card it restarts the box as per what should happen, but the box now stays at LD:20 and then goes to LD:30 and back and forth.I have left it to autoupd8 for over an hour now but its still doing the same!
I have also tried diff methods of saving the int &ext EEprom settings, and the flash.
Has anyone had this problem b4? Im getting ready to have a nervous breakdown here!!!

did you get this sorted m8 as im having exactly the same problem doin sammy 2100 on ex cw

[adjbeatbox]

This was caused with the wrong net id being inputed by the programmed card being set up wrong...If you get the same fault check your net id to make sure its the 1 for your area...

[ronster]

net ids spot on m8, Manchester 2 NTL/EX C&W, 41060 666750 6952
frequency and symbol rates right aswell m8
HELP its doin my head in

[reddiesel]

Only thing i can think of is have you got a good cable connection, if net id is right ,have you tried reboot a few times.

[javed]

Short the Battery for 15 seconds, which will delete the software as well as your net id, Then connect the cable feed.
Programm your card again.
Can you please tell us in which sequence you are writing the EXT and INT Flash Files ? i might be able to help you. doing so you can chenge the net id and if it is going to ld30 then it will pickup the new software and update your box. just let us know how are you programing the card. Because there is a small thing which most of the people miss.
thanks

[ronster]

@ javed,hi im loading the exteep then writing it then load the inteep and write it then the flash using infinity unlimited
@ reddiesel, ive got another modded box and a eurovox plus modem all running through splitters lol