flashed old starview with the box software not working PLEASE HELP

[kurt9]

Hi All
i know i have done a right stupid thing but is there anyway to get the box to talk again?
when i turn the box on all i get is a screen saying THE BOX
and i cant get the pc to talk to the starview box
anyone fixed this
please help
kurt

[V4vintage]

This sounds like my problem too mate. Have you had any luck with this?

Cheers.

[satsmo]

Connect the box to the pc with your cable but switch it off at the back. Load the correct firmware bin file into GTRom & set it to the correct com port, and select App file only then hit Download.
Only then switch on at the back to power on the box. It may take a few sec. so wait at least 30 sec.
(If it doesn't work 1st time try also waiting a couple of sec. to switch on after pressing download in the loader.) It may take more than 1 try to work, but eventually you'll see the loader kick in and the % bar increase. You won't see the % on the Starview though. Only green lines moving left to right. Towards the end of the flash you'll see a message in GTRom saying FLASH BURNING. Then it will reach 100% and wait for the download complete pop up box to appear & the box will reboot back to factory setup. You will have lost any channel data previously on the box & will need to rescan & switch on EMU and set the box up from scratch.

[kurt9]

THANKS
That worked a treat
kurt

[satsmo]

Youre welcome