T911 cyclone red unlooper dip switches

[Tezza1]

Hi all.
Finally got my T911 cyclone red unlooper. Not sure of the dip switch settings.
The tuts seem to have different switches.
This has 6 dips, the top of the dips says open, so looks like up is on, and no slider switch.

I managed to flash it to d13 with switched 1 to 5 up for on and switch 6 down.

Tried a few read settings, and seems to work to read with 2 and 4 dips up for open and rest down.

Ran B0D script on B0D and B0Cand it says unknow provider and exits.
Ran BOC script on B0C card and it runs, but only shows 2 bytes of data and then rows of ! ! ! ! ! ! and then read timeout error.

Ran VCC analyser using Rom 11 B0C and shows reapeted ++++++++++++++.

I dont want to adjust the pot yet until I'm sure about the dips.
Can anyone help please.

[reddiesel]

You want 2 and 5 down, you should have a random pattern of ++++ when it starts going you need to adjust the pot.

[Tezza1]

Thanks, it's good to know the dips for sure, looks like I was mixing up the open and closed, but still get same thing.

running VCC tester in win explorer can adjust pot and get the ---+++---++++ random pattern, but rom B0D script says Unable to identify provider exiting, on both B0C and B0D?
On BOC script runs showing lines of ! !! !! ! ! ! ! ! and then sc timeout read. This does same with no card in the slot. Have adjusted the pot, but stays as ! ! ! ! !

Is it the scripts? Using a variable psu 0,3,4.5,6,7.5,9,12 300ma 3.6va.
Have tried defferent voltage settings, but using 6v with VCC testing.

I'll re-read Javids useful notes, but any help would be appreciated.

[Tezza1]

OK an update. Ran an older script that said unlocks only B0C streamlocked and this was running OK. Adjusting power and pot varies from ___+++ and ! it found bug but could not accept the logon. So it is the script or power related. The new scripts seem to keep timing out, so need more power to hit the chip??
Maybe a regulated power supply may do it?

[Tezza1]

Downrated flash from newd13 to 11. More or less the same. Got a B0C script running OK and looks good on the --+++-- and an odd ! now and then, but running for an hour so far.

Some of the new BOC scripts do nothing but a few lines od --+++---++++ and then sc time outs?
My B0D script says uknow privider on both cards and will not continue.
Has anyone got any working B0D scripts please for winexplorer.
I can't seem to see a download section in this forum?

[jimbo]

better to use the mike data script.