IFA write process gets to 14% then stops

[stephent]

ok i flashed my dbox using the wrong image by accident. I am trying to reflash it using IFA. ITS pinging the box fine and starts the flash process. It gets to 14% backup then stops. I have restarted dbox by pressing power and up, but i get to the same point again. I have pasted the output below.

Any ideas guys?





This is what it says.

�ÿdebug: DDF: Calibrating delay loop... debug: DDF: 66.76 BogoMIPS
debug: BMon V1.2 mID 03
debug: feID 00 enxID 03
debug: fpID 52 dsID
debug: HWrev 61 FPrev 0.23
debug: B/Ex/Fl(MB) 32/00/08
WATCHDOG reset enabled
debug: autoboot aborted from terminal
dbox2:root>
dbox2:root> seteth
ethaddr 0x1001ffe3
ethaddr: 00:50:9c:3d:8a:b2
dbox2:root>
dbox2:root> boot net net net net net net net net net net
debug:
BOOTP/TFTP bootstrap loader (v0.3)
debug:
debug: Transmitting BOOTP request via broadcast
debug: Got BOOTP reply from Server IP 192.168.0.8, My IP 192.168.0.202
debug: Sending TFTP-request for file C/dboxifa_tmp/tftpboot/u-boot
will verify ELF image, start= 0x800000, size= 140008
verify sig: 262
boot net: boot file has no valid signature
Branching to 0x40000


U-Boot 1.1.6 (Tuxbox) (Jan 8 2007 - 22:58:00)

CPU: PPC823ZTnnB2 at 66 MHz: 2 kB I-Cache 1 kB D-Cache
Board: DBOX2, Sagem, BMon V1.2
Watchdog enabled
I2C: ready
DRAM: 32 MB
FLASH: 8 MB
FB: ready
LCD: ready
In: serial
Out: serial
Err: serial
Net: SCC ETHERNET
BOOTP broadcast 1
Using SCC ETHERNET device
TFTP from server 192.168.0.8; our IP address is 192.168.0.202
Filename 'C/dboxifa_tmp/tftpboot/u-boot'.
Load address: 0x100000
Loading: *Using SCC ETHERNET device
TFTP from server 192.168.0.8; our IP address is 192.168.0.202
Filename 'logo-lcd'.
Load address: 0x100000
Loading: *##
done
Bytes transferred = 7680 (1e00 hex)
BOOTP broadcast 1
Using SCC ETHERNET device
TFTP from server 192.168.0.8; our IP address is 192.168.0.202
Filename 'C/dboxifa_tmp/tftpboot/u-boot'.
Load address: 0x100000
Loading: *Using SCC ETHERNET device
TFTP from server 192.168.0.8; our IP address is 192.168.0.202
Filename 'logo-fb'.
Load address: 0x100000
Loading: *####################################
done
Bytes transferred = 179877 (2bea5 hex)

Options:
1: Console on null
2: Console on ttyS0
3: Console on framebuffer
Select option (1-3), other keys to stop autoboot: 1  0

Bank # 1: INTEL 28F640J3A (64M), 16 bit

Size: 8192 kB in 64 Sectors
Sector Start Addresses:
10000000 10020000 10040000 10060000
10080000 100A0000 100C0000 100E0000
10100000 10120000 10140000 10160000
10180000 101A0000 101C0000 101E0000
10200000 10220000 10240000 10260000
10280000 102A0000 102C0000 102E0000
10300000 10320000 10340000 10360000
10380000 103A0000 103C0000 103E0000
10400000 10420000 10440000 10460000
10480000 104A0000 104C0000 104E0000
10500000 10520000 10540000 10560000
10580000 105A0000 105C0000 105E0000
10600000 10620000 10640000 10660000
10680000 106A0000 106C0000 106E0000
10700000 10720000 10740000 10760000
10780000 107A0000 107C0000 107E0000
Using SCC ETHERNET device
TFTP from server 192.168.0.8; our IP address is 192.168.0.202
Filename 'kernel-yadd'.
Load address: 0x100000
Loading: *################################################ #################
################################################## ###############
##
done
Bytes transferred = 675073 (a4d01 hex)
.................................................. ............. done
Un-Protected 63 sectors
## Booting image at 00100000 ...
Image Name: dbox2
Image Type: PowerPC Linux Kernel Image (gzip compressed)
Data Size: 675009 Bytes = 659.2 kB
Load Address: 00000000
Entry Point: 00000000
Verifying Checksum ... OK
Uncompressing Kernel Image ... OK
Starting pid 11, console /dev/console: '/etc/init.d/rcS'

dbox2 - ImageFlashingAssistent

- Hallenberg -



Writing backup: 1152k von 8064k (14%)

[lincsat]

What image are you trying to flash onto the box, have you disabled the Firewall, Anti-virus and all other networking devices?

[stephent]

an old sportster 1.7 x1 image that i know works.

Yes everything is disabled. On the LCD it says backup and just stops.
Thanks for the quick reply mate. also get this message on the bottom of the output, this comes up when the backup hits 14%. Dont think i have a network prob though as i can ping the dbox ok.


nfs: server 192.168.0.8 not responding, still trying

[lincsat]

I get the Hallenberg logo on the LCD, Backup would suggest it's trying to read the image off the box to back it up to your PC.

All I can suggest is to try a different version of IFA

[stephent]

yea. i think ifa 1.5.6 doesnt back up the file, thus omitting the issue. I will try it and let you all know the results.

Thanks lincsat.

[stephent]

ok just tried IFA 1.56 and i get a different error. Doesnt get past Kein System with this version. Any idea what this output means?



ÿdebug: DDF: Calibrating delay loop... debug: DDF: 66.76 BogoMIPS
debug: BMon V1.2 mID 03
debug: feID 00 enxID 03
debug: fpID 52 dsID Hallenberg.com dbox2 Linux Umbau Service Neutrino d-box d-box2
debug: HWrev 61 FPrev 0.23
debug: B/Ex/Fl(MB) 32/00/08
WATCHDOG reset enabled
dbox2:root> debug:
BOOTP/TFTP bootstrap loader (v0.3)
debug:
debug: Transmitting BOOTP request via broadcast
debug: Given up BOOTP/TFTP boot
boot net failed

Flash-FS bootstrap loader (v1.5)

Flash superblock not ok: No bootrecord
boot flash /root/platform/sagem-dbox2/kernel/os failed

Flash-FS bootstrap loader (v1.5)

Flash superblock not ok: No bootrecord
boot flash /root/platform/mpc8xx-dbox2/kernel/os failed

Flash-FS bootstrap loader (v1.5)

Flash superblock not ok: No bootrecord
boot flash /root/platform/kernel/os failed

Flash-FS bootstrap loader (v1.5)

Flash superblock not ok: No bootrecord
boot flash /root.new/platform/sagem-dbox2/kernel/os failed

Flash-FS bootstrap loader (v1.5)

Flash superblock not ok: No bootrecord
boot flash /root.new/platform/mpc8xx-dbox2/kernel/os failed

Flash-FS bootstrap loader (v1.5)

Flash superblock not ok: No bootrecord
boot flash /root.new/platform/kernel/os failed

Flash-FS bootstrap loader (v1.5)

Flash superblock not ok: No bootrecord
boot flash /lost+found/root/platform/sagem-dbox2/kernel/os failed

Flash-FS bootstrap loader (v1.5)

Flash superblock not ok: No bootrecord
boot flash /lost+found/root/platform/mpc8xx-dbox2/kernel/os failed

Flash-FS bootstrap loader (v1.5)

Flash superblock not ok: No bootrecord
boot flash /lost+found/root/platform/kernel/os failed
dbox2:root>
------ Systeminformations ------
Selected networkdevice: Realtek RTL8139/810x Family Fast Ethernet NIC #2 - Packet Scheduler Miniport (0)
IP-address of the networkdevice: 192.168.1.8
IP-address which the dbox gets: 192.168.1.202
Operatingsystem: Microsoft Windows XP Home Edition Service Pack 2 (Build 2600)
------ Powered by Hallenberg.com dbox2 Linux Umbau Service Neutrino d-box d-box2 ------