net id using libby

[fez]

Hi guys can anyone help me ive got my rs232 serial cable from my infinity prog connected to my 1000 box and to the rs232 connection on my comp, and im using libby with the config file altered for my area, but libby is showing no connection when i try to set the net id. any help appreciated.

[spikebaby]

check your com port in your settings,

[fez]

Hi spike, yes i went into device manager and the com ports say this device is working properly am i right in using a rs232cable to connect or should it be connected from th rs232 connection on the box to printer port instead hope you can give advice on this thanx

[spikebaby]

connect with 232 lead, select you com pory and file let the stb connect all gobbdly goook on your right ..the select net id

[fez]

Originally Posted by spikebaby

connect with 232 lead, select you com pory and file let the stb connect all gobbdly goook on your right ..the select net id

Hi spike ive checked com ports in device manager all are working, ive set the libby to com 2 with config file loaded, and when i connect i get a "comms fail try again" in the right corner it says (b1)(b1)4026.

I then went into com stat and comms errors and all the boxes are clear showing no errors. if i connect the lead to the infinity programmer the prog works fine.

[fez]

Ive noticed that in libby wheni go into comms to set com it only gives me com 2 as open com 3 wont open com 4 wont open and there is no com 1. Ihave no idea why it does not show com 1, any help at all lads i would appreciate it