Obtaining IRD / BK From MOSC Card Using Dynamite+

[stick_dog]

Hi everyone.

After a lot of reading of this site, I have purchased a dynamite + programmer which I can connect either via USB or RS232as I was told that MOSC will only read via RS232. I have installed Nagra 4.0 and wish to read my MOSC card to obtain the IRD and BK so that I can then create a Fun Card which auto updates. When connected using RS232 on COM 1 I try to read the card but get the following error:

Opening of COM1 was successful
Reset Failed
Error re-setting card, ATR string invalid
Closing of COM1 was succesful

I have found this error on a number of posts, but cannot seem to find an answer to tell me what I am doing wrong.

Any help or pointers would be very appreciated.

Thank you in advance.

[lincsat]

MOSC's will only read over RS232 - you will need to unloop or unlock the card first. Have a look around for posts about un-looping

[jimbo]

Originally Posted by stick_dog

Hi everyone.

After a lot of reading of this site, I have purchased a dynamite + programmer which I can connect either via USB or RS232as I was told that MOSC will only read via RS232. I have installed Nagra 4.0 and wish to read my MOSC card to obtain the IRD and BK so that I can then create a Fun Card which auto updates. When connected using RS232 on COM 1 I try to read the card but get the following error:

Opening of COM1 was successful
Reset Failed
Error re-setting card, ATR string invalid
Closing of COM1 was succesful

I have found this error on a number of posts, but cannot seem to find an answer to tell me what I am doing wrong.

Any help or pointers would be very appreciated.

Thank you in advance.

if this was a mosc done before nov 06 its fryed no good, are u sure u have progger in phoenix mode.

[windy1603]

before you open naga make sure you are running cas studio with utilities pheonix 3.68 mode selected or nagra cannot read the card