Funcard 4 Info Needed!! plz

[v1ks]

Hi All i followed the steps below to program my fun card4, but not getting any channels.

• Open up Nagra and click on file then “open card image”. Select the file “NTL.bn11” (or the one for your cable company). >>

> >

• Click on “data editor” and change the boxkey and ird to your own. (the ird goes backwards). Click save as and rename it to “NTL.bin”.>>

> >

• Open up your programmer software and load “NTL.bin” as the external eeprom and “PURE_FUN_FIX” as the flash.>>

> >

• Write the files to the card and leave to update in box for roughly 5 minutes. I find flicking through the channels speeds the updating process up. >>

My 1st question is when i open the .bn11 in nagra do i also need to enter keys from the bigmaq tool bar for my area? as it set to key 0 = all 0's and Key 1 = all 1's as default.

secondly when entering the IRD isit definately backwards so my case it starts with 6B and not 12.

My reader (Usb Phoenix) supports bin files as ext_eprom so i didnt convert it to hex is that ok?

Do i need a Int_eprom or does it work without, i have seen in few thareads that you dnt need to but i just wanted to make sure.

Thanks for any help given.

[jimbo]

u dont have to reverse ird, never have, keys leave blanks taht way if it updates u know it au,s u dont have to change it to hex, and no u dont need int eep.

[v1ks]

thanks for jimbo for confirming. I dont know why people in tutorials say you have to reverse the IRD, can that cause the channels not to load?

[jimbo]

dont know i have never reversed the ird.

[v1ks]

cool i will change the IRD back to normal and test it.

Thx