d-box beginner

[thebigD1]

Switch OFF all firewalls and antivirus on your PC
(and make sure windows XP built in firewall is OFF)
. Power on the TV and DBox, but don’t hook it up to your PC yet.

Using the remote control, press DBOX > SETTINGS > NETWORK
Take a note of the DBox network settings
(this is an example only)

IP-Address 192.168.0.3
Net Mask 255.255.255.0
Broadcast 192.168.0.255
Def Gateway 192.168.0.2
Name Server 192.168.0.2

On the PC go to START BUTTON > SETTINGS > CONTROL PANEL and open the NETWORK CONNECTIONS

Right-click the network card (it may say Local Area Connection),
and select PROPERTIES > CONFIGURE > ADVANCED tab

Highlight the ‘Connection Type’ (in the left window),
and in the right ‘Value window there is a drop down menu (it will probably currently say automode)
Change the Value to 10 full mode then OK

Again, right-click the same connection, and go back into the PROPERTIES of the network card
There is a List of items in the first window (you may need to scroll down further)
Left-click on internet protocol, when it is highlighted, click the PROPERTIES button.

Select the ‘Use the following IP address’
Enter the settings, as you seen it on your DBox, except the IP address will be one digit less of the last number
(eg. 192.168.0.3 on DBox, so use 192.168.0.2 on your PC)

OK these settings.
Connect the RJ45 cable between PC and DBox (linking them together)

Run the Flash FXP program
On one side should be the files on the PC
On the other side make sure you select ‘ftp browser’ (the tab is a monitor and folder picture)
(It may already be selected)

Click CONNECT (the icon which looks like a lightening bolt)

Select QUICK CONNECT the three boxes require some information
SERVER OR URL = (enter the IP address of the DBox)
USERNAME = root
PASSWORD = dbox2

Then click CONNECT

You should now see the DBox files in the window (if not, check the IP settings).

. In the PC file window, browse to the folder containing the Image file you are going to use (eg. “the new blade oneIn the DBox window browse to the TMP folder (NOTE: you may already be in this folder).

Transfer the image file across into the TMP folder

When done close down the Flash FXP program.

(Now go over to the DBox)
Using the DBox remote control, press (in this order)

DBOX > SERVICE > SOFTWARE UPDATE > EXPERT FUNCTIONS > WRITE ONE PARTITION >
FLASH WITHOUT BOOTLOADER

Select the Image available (the one you just transferred over from PC) and select YES to flash

The DBox will start to erase existing flash, and write the new one (this will only take a few minutes)
The DBox will reset itself when done, and start up the new image

*** CONGRATULATIONS YOU HAVE SUCCESSFULLY FLASHED YOUR DBOX ***

)

[BelgyFaeEK]

a good one i like to use totally free is filezilla

Filezilla is an ftp client and ftp is File Transfer Protocol.