Stuck in 250 tut

[tigerfeet]

Hi, webstar 2100 being flashed with infinite. Following the 250 tut when you get to this part below--is this referring to the code part of putting the mac in or do you have to do something else. Also is it the working mac that is to be put here and not the nic. Would you have to do this..the part where it says 0xAABBCCDD and 0xEEFF replace the AABB etc with the good mac. Is this with upper or lower case. Then when getting to the part for usb, enter the mac and change the last digit etc to one higher. Also change serial to match the mac.

We now need to change the MAC address. We do this by writing the new ethernet mac into RAM first.

Assuming our MAC address is AA:BB:CCD:EE:FF (replace for the mac you want to use)


Code:
write_memory -s 4 0x807e8b98 0xAABBCCDD (press enter)
write_memory -s 2 0x807e8b9c 0xEEFF (press enter)

Hours getting nowhere except an headache,help would sure be appreciated.

Thanks! Hope you are having a nice day!

[badboy123]

Try ambit config tool to change your MAC, once you have changed it, go back into hyperterminal and change your USB MAC...hyperterminal is a bit like using command prompt...