Please help and advise on cable card issue

[rizlaman]

Originally Posted by blaise

New to all this and defo new to nagra. here is what i am doing:-

Setting phoenix usb reader in phoenix mode 3.68. placing *tl card into reader. Opening up nagra and clicking on 'card'. Then selecting ' read from card '.

Then getting :- " Opening of COM2 was successful
Reset failed
Error reseting card, ATR string invalid
Closing of COM2 was successful "

What am i doing wrong?

Have you unlocked the card?if every thing is pluged in properly and in right modes and you are still getting this message then the card could be nackerd.

[reddiesel]

Give the contacts a good clean on card, click on reset atr left of read a few times, if you get same atr error card is dead.

[davyonion]

hi will i be able to programe a n*l card if i get a infinity programer and if i can what do i have to do thanks

[ronster]

yes an infinity will work but i think you need a good read up first mate on whats needed and how to do it!
Use the search function as all these questions have been answered a hundred times,
if and when you get stuck we'll gladly help!

[mk753]

Originally Posted by davyonion

hi will i be able to programe a n*l card if i get a infinity programer and if i can what do i have to do thanks

Hi m8,
Normally when you get the message no ATR or ATR invalid its the h/ware problem, i mean the connections and not the card. Check that your programmer is in phoenix mode 3.68 and minimised / hide and then goto Nagra Edit, Reset and then Read Card (The tab with blue arrow). You would hopefully be able to read the ATR but not sure if you could read the BD0 and BD3, normally it should be locked even if the card is MOSC (reprogrammed before), it is because of the blockered image that is usually loaded on the card. To unlock, you would need an Unlooper and the correct script and then use Winexplorer 5.1, load the required script and then run it with the card in the Unlooper. It should open the card for you. You can then load the image of your area with your BK and IRD onto the card using Nagra Edit 4.1 (Win 98 mode). If you have the IRD and BK you might not need the Unlooper. Just send the Bo9.A3 file to the card using Nagra Edit, it should open the card for you... ONLY use this method if you have the BK and IRD as it will erase the info from the card. Once open you can then send the required image to the card.

Good luck...

[davyonion]

thank you for info i will get back to you when i get my programmer

[davyonion]

hi again i am trying to get info of bigmaqtoolbar but every time i try to register i get internet has problem send error report dont send is there any other site i can go to get the info on how to start chipping a box and programme the card thanks

[bramleyandy]

looke here m8 all you need fileaddictions.com

[davyonion]

hi again ihave a replay lite box and it does the same thing as n*l i was able to flash it do you have to do the same with n*l box or do you just do the card thanks