Need some help please refrence willem and 29lv160

[dstream]

Im using the willem 4.5 with tsop 48 on board. Im programming the full config file. infinite250.bin a whole 2meg worth.

heres where the problem comes every time and i mean every time no matter what chip I program, I get error 0x80000 buffer 0xcd chip 0x21.

Am i missing something its 2 days ive been trying to get this to work. Chip is removed with an smd rework station id`s perfect .

psu is kicking out 12.9 volts.

blanks perfect blank check is perfect says chip empty.

is there something simple like a boot loader i should be just sticking on??

downloaded from another working modem and this is prob where all the problems are starting?


arrrgghhhh!!!!

[G77]

is there a jumper on the willem for the tsop adaptor? the adaptor needs to be in lv (low voltage) mode.

[bumbumak47]

use only jumpers on Vcc and 29v side chip holder...

ur also using wrong firmware....u need the cbtc, bbtc hex files etc...look around for them the webs a wonderful place....

u may get errors erasing this can happens specialy with cbtc chips....says not emptey dont worry bout that though i recomen let it go the few % around 3 times to make sure, clear buff, load image, write image then its ready to go....

had a nightmare at first myself...