Using a working MAC address - Techwatch Support Forums: Digital & Satellite TV, FTA, Cable, Computers, Mobile Phones, Apple and General Tech Forums

imran222 · 28-05-08, 11:32 PM

Hello,
I have recently purchased a flashed surfboard 4200, loaded with fibercoax. I just need to enter the MAC address. I have 2 questions:
1- Can I use the MAC, which is registered in london borough of redbridge @ ambit255, and I am in london borough of Newham (about 6 miles from redbridge)?
2- Working ambit 255 is subscribed to get 2mb speed, if I change my surfboard's speed to 20mb, will there be any problem?
Please help

Boltar · 29-05-08, 08:18 AM

Yes and Yes.

6 miles is good, and if the firmware allows you to force config then yes you can just change the config to 20 meg.

i did it · 29-05-08, 08:54 AM

there is a sniffer programme that allows you to sniff and use the macs in the result by solster ( topman and all credit goes to him and the others who made it sorry off hand cannot remember the others sorry ) called dwsniffer
not sure if allowed to upload or where to ( am new here lol )
have a look for this programme for your needs
regards

28-05-08, 11:32 PM	#1 (permalink)
imran222 Junior Member Join Date: May 2008 Posts: 12 Thanks: 1 Thanked 0 Times in 0 Posts	Using a working MAC address Hello, I have recently purchased a flashed surfboard 4200, loaded with fibercoax. I just need to enter the MAC address. I have 2 questions: 1- Can I use the MAC, which is registered in london borough of redbridge @ ambit255, and I am in london borough of Newham (about 6 miles from redbridge)? 2- Working ambit 255 is subscribed to get 2mb speed, if I change my surfboard's speed to 20mb, will there be any problem? Please help

29-05-08, 08:18 AM	#2 (permalink)
Boltar Junior Member Join Date: May 2008 Posts: 29 Thanks: 0 Thanked 3 Times in 3 Posts	Re: Using a working MAC address Yes and Yes. 6 miles is good, and if the firmware allows you to force config then yes you can just change the config to 20 meg. __________________ AKA Overburnit - Cable King.

29-05-08, 08:54 AM	#3 (permalink)
i did it Member Join Date: May 2008 Posts: 48 Thanks: 0 Thanked 7 Times in 7 Posts	Re: Using a working MAC address there is a sniffer programme that allows you to sniff and use the macs in the result by solster ( topman and all credit goes to him and the others who made it sorry off hand cannot remember the others sorry ) called dwsniffer not sure if allowed to upload or where to ( am new here lol ) have a look for this programme for your needs regards

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
how do i change the NAT from moderate to open on a Netgear DG834GT router??	rossy	Broadband	5	11-07-09 04:12 PM
How do I find a working mac address?	johnhope1	Cable Modems	4	21-06-08 07:51 PM
Updated Eurovox working fine for a few weeks now remote won't and sound disappears!	abbas_ali	Eurovox	3	10-05-08 11:57 PM
Prem? on Dreambox 500s	kerrywez	Satellite Help	33	27-09-07 11:51 AM
Settings For WAp / GPRS All Networks	Realist	Unlocking	0	18-09-05 11:40 AM