powersync tut ?

[mikk]

Apologies if i've missed it but cant find a tutorial for using unloopers. If there is one could someone point me to it.

[reddiesel]

Originally Posted by mikk

Apologies if i've missed it but cant find a tutorial for using unloopers. If there is one could someone point me to it.

In downloads glitching.

[mikk]

That is for the T911. Am I right thinking the ps is pre flashed and is the pot setting the same? I can only see four switches on the powersync, should I choose sidewinder as the best sw?

[reddiesel]

Originally Posted by mikk

That is for the T911. Am I right thinking the ps is pre flashed and is the pot setting the same? I can only see four switches on the powersync, should I choose sidewinder as the best sw?

Not sure if its flashed ,contact supplier, sidewinder will give you boxkey but wont unlock it, do a search i think theres a thread or two on p/snc.
Use 1 dip at a time, 2 or 1 down for script, 5 down to flash, newd11 will work.

[mikk]

There are four switches on a small blue block. It came with number1 in the 'on' position ie. up, and two, three and four down. Although printed on the board it say ; 1 thru 4-clock settings. 5-on to flash, 6-7 unused there are only 4 swiches and what looks like a diode at end??

[reddiesel]

Originally Posted by mikk

There are four switches on a small blue block. It came with number1 in the 'on' position ie. up, and two, three and four down. Although printed on the board it say ; 1 thru 4-clock settings. 5-on to flash, 6-7 unused there are only 4 swiches and what looks like a diode at end??

Are you sure on position is up ? its normally down. if it has an adjustable screw thats a resistor (pot) you adjust vcc.

[Steve67474]

Hi M8 I have a powersync the switches are as follows 1 on all others off. If it came from TMC then its preflashed with Newdx11 (mine was at least) Siudewinder 1.2 will open cards I have done several rom11 bods with it. TBC's programme is the dogs as it doesn't need winexplorer. Sidewinder 1.4 will give you boxkey from a locked card. Hope that helps m8. PS the diode at end iis just a link as it used to be a switch on some unloopers and this was used for flaching amtel. you dont need to worry on powersync just ensure 1 is on.