Eurovox 2 power scan no channels

[fattyboy]

the box was working fine at my house when my mate went home and delete all channels then rescan it did not work try it again at my house did not work.also flash it again with softwere.
any help please.

[jaysbee666]

try this m8, it might be of some help with symbol rates..
Basic Settings
Press MENU on your remote control
Select the “installation” icon and press OK.
Press the yellow button to select POWERSCAN.
Cable television normally uses one of three symbol rates; if you are unsure of your symbol rate then leave it set at 6.952 and proceed, If you find only a few or no channels then repeat the user installation but press down key 3 times and change the symbol rate to 6.887, if this fails to find any channels then use 6.875. If you already know your symbol rate then enter it now.
Press OK to start the scan.
After about 20 minutes your receiver will finish scanning and all channels should be found.
You should now have a basic setup; you may need to wait a few minutes the first time you select a scrambled channel for the key to update. If any channels seem to be missing then check carefully as they may be listed with nondescript name, i.e. Channel X may be listed as TVCh 12, you can change this in Channel Manager. Also the channels will not be in the order you are used to but again you can change this with the Channel Manager and you can use the Favourites Manager to put them into groups for fast access.
If any of the Channels seem to “disappear” then simply perform an Auto scan to restore the missing Channels.