v+ net id and freq

[easyas123abc]

Cheers rizlaman but mine is all green in page 1 so there is defo signal... i have no clue what to do and i dnt like removing chip headach.

[rizlaman]

Originally Posted by easyas123abc

Cheers rizlaman but mine is all green in page 1 so there is defo signal... i have no clue what to do and i dnt like removing chip headach.

have u chased cable out to make sure all connected out side
wat box is it you are using?

[easyas123abc]

yep is all working it even works with my subbed one. its a sa8300.

[rizlaman]

Originally Posted by easyas123abc

yep is all working it even works with my subbed one. its a sa8300.

I dont know alot about the sa8300 only done 1 but i remember with the 4001s if to much presure is put on cable conector on back it could brake causing a bad connection so would have to resolder.this is a very puzzleing situation it will proberly be some thing very simple just hope you figger it out mate.rizlaman.

[afcwomble]

Originally Posted by easyas123abc

Also i like to add that the netid is not 09999 is the netid from where i got the box from.

Please help

You will be lucky to get NetID to change from the area it's on now to a new one without lifting chip. Some people have aid they have done it with success but I beg to differ as i've ALWAYS had to lift chip. You will need either a blank chip to do the atmega trick but on my last one I used the dump I got from my Willem and changed it using the TV Drive Tool(in D/Loads), reprogramed the chip and resoldered it back in. You have to be very careful removing it though as the pads are really delicate-I used a Solderpro on low gas with plenty of flux-ease up one side with a scalpel blade giving a little force(and I mean little)-let the heat do it's work and it will come off. Remember which way round it went as well-made that mistake before and put it back the wrong way and had to remove againGood luck mate

[jamie1984]

im probably wrong but dont you write externaleep first then the flash last as when you write externaleeprom its wipes the card(i am prob wrong i have only used funcards to change netid on paces so im a bit of an amateur)

gl

[rawsy]

i think the flash wipes the card when you read it but if your using a infinity pheonix or similar it will sor t all that for you anyway so just tell it which files you want then click write.

[seamouse]

thanks to a member of this site i got my bk and ird for my box which is same area, i made a FUN CARD and box did not reboot, could get all channels and no drive action. So i hit reset and box came on, waited 2 mins to load and got all hard drive actions...

maybe its the card?

[rawsy]

Originally Posted by seamouse

thanks to a member of this site i got my bk and ird for my box which is same area, i made a FUN CARD and box did not reboot, could get all channels and no drive action. So i hit reset and box came on, waited 2 mins to load and got all hard drive actions...

maybe its the card?

he is trying to get the net id to change not the channels yet mate.

keep at it mate i have managed to change the id with out the chip beign lifted it took me a full day messing around but it did work in the end.

[seamouse]

cheers rawsy didnt see