v+ net id and freq

[easyas123abc]

Cheers rizlaman but mine is all green in page 1 so there is defo signal... i have no clue what to do and i dnt like removing chip headach.

[rizlaman]

Originally Posted by easyas123abc

Cheers rizlaman but mine is all green in page 1 so there is defo signal... i have no clue what to do and i dnt like removing chip headach.

have u chased cable out to make sure all connected out side
wat box is it you are using?

[easyas123abc]

yep is all working it even works with my subbed one. its a sa8300.

[rizlaman]

Originally Posted by easyas123abc

yep is all working it even works with my subbed one. its a sa8300.

I dont know alot about the sa8300 only done 1 but i remember with the 4001s if to much presure is put on cable conector on back it could brake causing a bad connection so would have to resolder.this is a very puzzleing situation it will proberly be some thing very simple just hope you figger it out mate.rizlaman.

[afcwomble]

Originally Posted by easyas123abc

Also i like to add that the netid is not 09999 is the netid from where i got the box from.

Please help

You will be lucky to get NetID to change from the area it's on now to a new one without lifting chip. Some people have aid they have done it with success but I beg to differ as i've ALWAYS had to lift chip. You will need either a blank chip to do the atmega trick but on my last one I used the dump I got from my Willem and changed it using the TV Drive Tool(in D/Loads), reprogramed the chip and resoldered it back in. You have to be very careful removing it though as the pads are really delicate-I used a Solderpro on low gas with plenty of flux-ease up one side with a scalpel blade giving a little force(and I mean little)-let the heat do it's work and it will come off. Remember which way round it went as well-made that mistake before and put it back the wrong way and had to remove againGood luck mate