v+ net id and freq

[easyas123abc]

I got my ird and bk which is correct.

When I put the atmega in on the net id page in the eng menu the box dose not reboot.

Also when i set the freq it reset it self wen i restart the box?

any advice please

[spikebaby]

when in eng menu turn the pages over then put atmega card in ....

[easyas123abc]

turn pages over do you mean any page or to a spefic page?

Also is a a specifc way I should be writing the card e.g. flash 1st ex 2nd and int 3rd?

Thanks

[rizlaman]

Originally Posted by easyas123abc

turn pages over do you mean any page or to a spefic page?

Also is a a specifc way I should be writing the card e.g. flash 1st ex 2nd and int 3rd?

Thanks

put flash in then put the ex in then write dozent realy matter wat order.then go to the page in engeneers menu were net id is and insert card.

[easyas123abc]

Originally Posted by rizlaman

put flash in then put the ex in then write dozent realy matter wat order.then go to the page in engeneers menu were net id is and insert card.

I do that but the box dose not reboot also i change the pages and no result.

[easyas123abc]

Also i like to add that the netid is not 09999 is the netid from where i got the box from.

Please help

[easyas123abc]

When i put the card in it displays Card status no t stream and version DNASP010 abd RevA16

I have left the card in for 20 min and it just stay there and dose not boot.

Please helpppp GUYS

I dnt wanan lift any chipss

[spikebaby]

no t-stream is no signal coming in check connections

[easyas123abc]

spikebaby check the connections no luck.

In page 1 is displays all green (receving singal)

[rizlaman]

Originally Posted by easyas123abc

spikebaby check the connections no luck.

In page 1 is displays all green (receving singal)

Mine says not in stream and its still working i thought this was normal maybey iv got a bad signal main thing is its working.
if its sasys signal is ok it should work