unlooper

[brayo]

hi
how do i go about adjusting the port settings on a tiny unlooper
im trying to unlock REV BOD

[rizlaman]

Originally Posted by brayo

hi
how do i go about adjusting the port settings on a tiny unlooper
im trying to unlock REV BOD

vcc anerlyzer its in the down loads.

[brayo]

ok thanks

how do i use vcc analyzer???

[imybash]

hello m8,

i had this problem, when i first bought the tiny unlooper from chartman, i didnt know anything about it. but after harrasing ppl on this form and chartman i managed to figure it out.

You need a few peces of software, Dexter's WinExplorer V5.42 works well, VCC Analyzer V3 and a phoniex based programmer!

1.Open Dexters WinExplorer and drop the (WinExplorer Info file into the program, just drag it in and drop it)

2. Run VccAnalyser (should be able to get it from this form in downloads, pref VCC Analyzer v3) When you have located this script click the "FILE", "OPEN SCRIPT" on Dexter's Winexplorer and find that VCC Script and then in dexter click "CARD", "EXECUTE SCRIPT".

3. You should see a load of numbers on the right have side e.g. 1a 2b etc.. you basicly neeed to turn the copper screw to aling the pot to a certian VCC. for Rom11 RevBOD its best to set it to around 1A or 19, to keep turing the screw until on line 1A theres all -------- and no +++ in them this will set the pot to the correct VCC.

4. Once you have that set up, open the script you want to run, i recommened (MIKEDATA & CHARTMAN A86 AND BOD SCRIPT MAY 2007 A86) itll do it in a couple of mins! Baicly open the script liek you did with that VCC analyser and run it! it should work if you get errors like oops card returned incorrect bytes etc.. try reseting the ATR in nagraedit 4.1.

Also note! you need to connect the tiny unlooper to ur serial port on the back of your computer, and need a decent power supply, make sure the voltage is correct and the OMz etc.. as the piece of paper you got with the unlooper will explain.

I hope this helps, as i had the same problem, i was told to unloop the card so i bought an unlooper and then ended up not knowing how to use it, also, its a matter or trial and error with unlooping, the more you do the better you get, so if you have a few spaire Rom11's / 10's test it before you do it on a proper card which you need to retrive the BK off. PS if you just want the BK from the card id use a small program called Sidewinder EXCELLENT program and works really well with Rom11 RevBOD. Hope this help, and dont forget to hit the thanks button

[brayo]

cheers imybash
thanks for your help!!!