mosc

[afcwomble]

Have you flashed the unlooper yet? And there will be a small screw with a flat head on(the POT) so you can adjust it with a small flat screwdriver. Where did you get the unlooper?

[afcwomble]

Originally Posted by clarkyj

dont understand about pot etc, , there r numbers from 1 to 6 on my t911 unlooper

The 1-6 are the DIP switches-normally you would use DIPs 1 and 6 ON, 2,3,4,5 OFF to flash the unlooper and DIPs 1 & 5 ON, 2,3,4,6 OFF to use in unlooping mode.

[clarkyj]

ok i got the unlooper out of tmc

[sharkbait559]

The unlooper should already have the correct settings and stuff already, mine did anyway...

[clarkyj]

im stumped

[jimbo]

havnt got a t911, so i cant confirm, but it should have a little square with a small screw in it, that u turn slightly to adjust the vcc.

[sharkbait559]

The closest thign to that i have is a circular plate witha plastic screw of some sort in it

[afcwomble]

If it's from TMC its probably got an acrylic top on it? I havent got one of these myself but similar to the old modded T911. I am presuming these already come flashed?(If someone can confirm) It looks as though it has a plastic round screw(The POT) to the rear next to the power inlet-this is what you adjust to get the VCC down/up to adjust. You will need a thin bladed screwdriver to do this. Try adjusting a 1/2 turn at a time and run script each time-like I said it will eventually reach a top/bottom end where it will "Click"-if it does go the reverse way doing the same thing-it should get a point where it will run script and you can adjust the POT again to reduce/increase VCC to suit.

[sharkbait559]

Yes they come already flashed with the correct setting already done

[afcwomble]

@clarkyj - have you got the windows script control installed? (sc10 programme)