Sagem dbox2 1x - sportster neutrino.. FTP?

[20792]

I basically wanted to get a permanent fix ( autoupdate fix) for my dbox so that i can stop manually updating keys.

I have been trying to make my dbox talk to to my computer but it just wont connect.
..My modem is connected to the PC via a USB cable.

I have connected my dbox with a crossover cable [ CAT.5E UTP CABLE ]

The following are my settings

The PC Local Area Connection is set to
IP Address 192.168.1.2
Subnet mask 255.255.255.0
Default Gateway 192.168.1.1

Dbox is set to
IP address 192.168.1.3
Subnet Mask 255.255.255.0
Default Gateway 192.168.1.1

i tried 2 ftp programs.. with all my anti-virus/firewall disabled

Flash Fxp and loaded the setting of User= root
password = dbox or dbox2
Port :21

Cute FTP Proffessional and loaded the setting of User= root
password = dbox or dbox2
Port :21

In both of these i get the same result Connection timeout


Can anyone give me any suggestions or a step by step tutorial to solve my problem.......???


Thanks in advance

[plasterer]

Try Link Below Mate Paul ...

plasterer

[20792]

Thanks Plasterer
but i guess what i did above is almost the same thing??

[Rodboy]

Originally Posted by 20792

Thanks Plasterer
but i guess what i did above is almost the same thing??

Configure your LAN link speed / duplex mode to 10 Mbps/half duplex.

[TwinTown]

i always use router m8 but i think u have to disable other network connections.....on board lan / other network cards....

[Frederick]

is networking enabled on the dbox image ?

[Sc00by]

i just did mine now mate been having a lot of problems with it

i used the guide plasterer linked earlier and now i am able to ftp successfully using FileZilla

all it took was being able to set the static ip for the dbox...then making sure you set the dbox ip as it instructs in that guide


good luck

[20792]

thanks alot guyss

after hours of trying i succeded finally

anyway i loaded all the updated keys in....but i dont get all the channels
it just comes up as black screen any ideas??

[plasterer]

Try Restarting the Cam
If you got one ........Paul

[20792]

hey thanks tried to restart evocambut no luck still