V+ Box paired card ?

[mikey]

Hi M8s I have been given a V+ Box which has apparently been disconnected before cancellation. So hopefully the card is still paired. I have looked in the engineers menu and the card status with the card inserted and the cable disconnected is No T Stream and the card type is DNASPO11 Rev BO4. Does this mean the card is paired ?

[ouzi1212]

if card status is OK then the card should be paired to the box, because the cable connection was disconnected it should No T Stream, as its rom11 revb04, u card unlock in xncs, wont need an unlooper, make sure the netid is set to ur area, if not then u will need to blank the chip or get a new one, then change netid

[mickyfinn]

hard to tell i have one that says card paired as long as the ird is correct even if the bk is incorrect (1234567890abcdef0). you just have to try and see if it works. sorry!

[ouzi1212]

if bk starts with 6D 56 then its false number

[spikebaby]

you will find that a bo4 image is an open image and these images are not incorporated by the cc, that is a image that has been modified, so this could be an expensive door stop, if you get the correct bk from it you will be very lucky

rom 11 bod
rom 10 A86
rom 7 718

these are the revisions that the cc use apart from ireland

[mikey]

Thanks for all your replies. I am running XNCS v1.8a. I have the message Now working do not interupt. How long will this run for ?

[spikebaby]

Originally Posted by mikey

Thanks for all your replies. I am running XNCS v1.8a. I have the message Now working do not interupt. How long will this run for ?

youonly need to dump the card takes 2mins tops

go to settings tick all boxes apart from ghost must be in eepron hit the blue button the card will then dump, hit it again the card details are in data editor