ambit 200 problem. help needed

[one2b3]

started programing an ambit 200.

got to the point where the X2Build128.bin file was uploded to it and i could see that on hyperterminal everything went fine untill the end where i said Y to saving to flash!

now i have a half working modem.

dont hav p option anymore.

now have

CM\
and
cm\help

If any one knows how i can re install the X2Build128 from the point im at or re install the original Firmware (if needed)

Please help

cheers

[Joker]

hey up m8 see if softjtag picks it up if it does great quick fix but dont worry 200s are unbrickable as blackcat can revive em
.. i would check the tsop to see if its btc chip as this is bad ,, if its abtc bbtc cbtc ect then this is good but try soft jtag first be carefull
msn me if ya need help

[one2b3]

nice one

soft jtag connects to the ambit 200 via max232 but is unable to write the bootloader to flash! and needs to reboot.

yes i have a BTC tsop chip too!

how do i get around this with the blackcat?

do i need to solder a 10 pin header to the pcb and use schwarze katze software to program the board?

cheers

[Joker]

hmm btc will only take origional firmware sorry if i find the flash ill up it are you any good at soldering tsops lol if so make it a lot easier but not to worry i will look for orig firm and post it l8tr
and yes it will need blackcating if softjtag does not connect sorry.. easy enough to do..

[Joker]

give me the letters and numbers befor the btc just to clarify the chip as well ta lol sorry i forgot to ask ie 1234567btc / or1234567abtc

[one2b3]

so a 29lv160BTC 90 tsop will only take origional firmware? so i cant put modded firm ware on it?

bcm3348 main chip