Mosc card problems

[mad-man]

Originally Posted by londongeeza

It reads fine!!!

wot does it say when read?

[londongeeza]

It was reading, i got 96% efficiency , but since ive attempted to write i now get this upon a read request

Opening of COM1 was successful
ATR String: 3F ** ** ** ** ** 81 71 A0 47 00 44 4E 41 53 50
30 31 30 20 52 65 76 41 33 32 4B
ROM Revision: 010
EEPROM Revision: RevA32
ProviderID: 40
CamID: 1B ** ** **
Using BD3 Key: 4E ** ** ** 45 72 20 49 73 20 61 20 62 75 54 74
Attempting to login to BD3
BackDoor login verified
Dumping Dataspace
Error sending BackDoor 0 EMM
Write error encountered, attempting to restore original decrypt keys
ProviderID: 40
CamID: 1B 83 F0 D8
Attempting to login to BD3
Decrypt keys successfully restored
Reading ROM10 failed
Closing of COM1 was successful

I think im going mad!!!! Should i unplug and try again???

[londongeeza]

And now im in again with this!! Why does this keep happening?

Opening of COM1 was successful
ATR String: 3F ** ** ** FF 91 81 71 A0 47 00 44 4E 41 53 50
30 31 30 20 52 65 76 41 33 32 4B
ROM Revision: 010
EEPROM Revision: RevA32
ProviderID: 40
CamID: 1B ** ** D8
Using BD3 Key: 4E 69 ** ** ** 72 20 49 73 20 61 20 62 75 54 74
Attempting to login to BD3
BackDoor login verified
Dumping Dataspace
Using BD0 Key: ED CA ** ** ** 22 33 44 55 66 77 88 99 ED CA 5E
Attempting to login to BD3
Attempting to login to BD0
BackDoor login verified
Dumping CodeSpace
Reading ROM10 successful
Card read successfully
Efficiency: 92.2%, Packets: 141, Retries: 11, Time: 35.25s
Closing of COM1 was successful

I apologise if im taking this thread somewhere beyond its original posted purpose. Trouble is ive no control over where this problem is takin mee!!

[londongeeza]

So long as i have my BK and IRD will it be ok to reset the card and re-program it with a image, nagra and infinity? Or will i need other software or hardware once thats done??? If i were to reset, is their any data i need to record of the card before hand???

Cheers folks! Always appreciate advice (good or bad)

[Roco]

its prob just a connection problem mate ,try different connections , try another pc if you have one,try different settings on your card programmer ect when writing your card

gl pal