Help with reading card for 2110

[G77]

hi folks, i picked up a 2110 at a car boot today. it already had the ird written on the bottom of the box but no bk.

the osc in it had a number 2 written on it and it looks like the same pen used to write the ird on the box.

i cant get in the bloody card though. when i read in nagra i get this....

Opening of COM1 was successful
ATR String: 3F FF 95 00 FF 91 81 71 A0 47 00 44 4E 41 53 50
30 31 31 20 52 65 76 42 30 44 3C
ROM Revision: 011
EEPROM Revision: RevB0D
ProviderID: 00
CamID: 00 00 00 00
Using BD3 Key: 4E 69 70 50 45 72 20 49 73 20 61 20 62 75 54 74
Attempting to login to BD3
BD3 login failed
Reading ROM11 failed
Closing of COM1 was successful

#When i try to unloop, sidewinder detects that there is a card in my powersync and trys to start glitching but doesn't. it just stops and the two 'progress lights' up top on right just blink very slowly.

if you notice the cam id is set to zero's in what i pasted. sometimes it comes up as F's.

any advice is greatly appreciated. i really dont need another 2100 gathering dust. i've had 3 so far which have been 5dead but with this already having the ird on the bottom i thought this might have been previosuly modded and would give me a correct bk.

[Roco]

ProviderID: 00
CamID: 00 00 00 00

change the settings in phoenix mode & you should get a reading for provider & camid,you could get really lucky & it might read the card

i not familar with sidwinder though as i prefer to use winexplorer so hopefully someone can help you there

[G77]

done that, still no go. thanks anyway

[blakey_8]

PM sent G77.

[G77]

still struggling with this. winexplor scripts crash and sidewinder crashes.

the annoying thing is the box says that card is ok when its in the slot on stream

this card has been messed with before thou.

[sharkbait559]

u sure its been plugged into cable stream mate as u need to otherwise its a no go, never seen that tho onli when i seen sumin who played around with his card.

[G77]

i dont quite get what your saying. yes, i put the box on stream with this card in and in eng menu is says that the card status is ok.

like i said in the above post, theres a good chance that this box has already been modded as the ird was written on the bottom of the box and the card had been written on in the same marker pen.

am i right in thinking that if a card has a valid atr that its ok?

i know theres nothing up with my unlooper and programmer or any of my settings as its just this card.

[Steve67474]

M8 use mrom to reset the card. DO NOT repair just reset then check the ird with wots on bottom to see if it matches. I use sidewinder have you tried adjusting the pot on your powersync whilst you are running sidewinder rom10 =1a to 1b rom 11 = 26 to 27

[G77]

yeah, done all that mate. just going to give up now i think

[sharkbait559]

and do u need the bk m8 if not use rom11 rapir or d2c.