pace box keeps updating every 10 mins

[jamie1984]

hi guys i would really appreciate a little help and advice, i have a pace 1000 which was on s.london i used a funcard to change netid to n.london to box loads up i insert mocs card i get all channels but every 10 min it says updating and reboots and the numbers roll as if it is hitting again

i am confused i tried using a differrent flash on the funcard but no luck

any ideas,

thanks.

[wizboxes]

did you put the red jumper back in place as if its not there it wont hold any info

[jamie1984]

hi thanks for your reply, yes i put the jumper back in place after and when i go into eng menu the netid is right even when i turn power off for ten seconds

[River-Rat]

sounds like the caps going? its on vm menus right? sim in place ok?

[tdubman]

you might get out off trouble by taking it back too cw.pull the jumper let it do a full roll then just change the net 40985 put 411.000..as defalt then take it back to north ....them 1000 dont like goin to tw...when they have been on cw

[jamie1984]

ok so i should change back to cw then try again to go bk to tw and use 411 as d.f i was using 515.000 ill do that now and see if it works
thanks

[tdubman]

make sure u let it roll in cw and pull the jumper .....when you are happy its not going into a roll again take it off and bung tw in it with what isaid dont force a roll when you get back to tw .....if it does the trick hit the thanks button mate good luck

[geforcefx]

anyone know how to update the Di4001 model ...............thx

im only getting about 6 more channels + 1,2,3,4,5 )

[wizboxes]

the di4001 will update after the red jumper has been pulled and set its own net id in pure

[geforcefx]

@ wizboxes m8 .... do u know were abouts the jumper is ! i cant seem to see any diagrams on were abouts it is & do u have to pull them completely off .or ? /iv never pulled a jumper b4 m8 , but iv seen them in my pc on the main board are they the same as them ...thx again m8