Coding for fix

[Zek176]

can someone with coding knowledge help me out . I have added the code below to the chaos source (along with changing keymask), and complied it. I have just done a fun, with both keys set to all 0's, but this bit of code seems to have done the trick, as channels are know on, just not sure if this will handle a key change or not?

LDI R27,0x01
LDI R26,0xB3
LD R16,X
SUBI R16,$3E
ST X,R16

LDI R27,0x01
LDI R26,0XB9
LD R16,X
SUBI R16,$42
ST X,R16

Anyone help ?

Ta
Zek

[mickyfinn]

Im not a coder but if the keys were 00000`s then it has already done the key change, as you can see channels.

[rizlaman]

Originally Posted by Zek176

can someone with coding knowledge help me out . I have added the code below to the chaos source (along with changing keymask), and complied it. I have just done a fun, with both keys set to all 0's, but this bit of code seems to have done the trick, as channels are know on, just not sure if this will handle a key change or not?

LDI R27,0x01
LDI R26,0xB3
LD R16,X
SUBI R16,$3E
ST X,R16

LDI R27,0x01
LDI R26,0XB9
LD R16,X
SUBI R16,$42
ST X,R16

Anyone help ?

Ta
Zek

Well if it has updated then its auto updating so post up the flash if you dont mind so other people can take a look up to you but its got to be better then entering the keys manualy way area is it for? i cant coad, read like f*ck just cant get my head round it.rizlaman

[Zek176]

Originally Posted by mickyfinn

Im not a coder but if the keys were 00000`s then it has already done the key change, as you can see channels.

What i ment was, this code at the minute gets a fun to AU with the correct keys.
Just not sure if it would if a key change happened.

[Marc]

Well effectivley if it has changed the keys from 00000000000 into a working key without it swapping back then it should handle the keyroll,try resetting the keys to be a few digits out and then put it back n the box and see what you get then,

Marc

[rizlaman]

Originally Posted by Marc

Well effectivley if it has changed the keys from 00000000000 into a working key without it swapping back then it should handle the keyroll,try resetting the keys to be a few digits out and then put it back n the box and see what you get then,

Marc

Sounds to me like it au fine and you have basicaly got a fix already are you using this on a 2110?

[andyd76]

Originally Posted by Zek176

What i ment was, this code at the minute gets a fun to AU with the correct keys.
Just not sure if it would if a key change happened.

Good work Zek, means nothing to me but i appreciate the work you're doing whether it works or not.

[Zek176]

Originally Posted by Marc

Well effectivley if it has changed the keys from 00000000000 into a working key without it swapping back then it should handle the keyroll,try resetting the keys to be a few digits out and then put it back n the box and see what you get then,

Marc

I think its a no goer, did what Marc advised, but it aint AU'ing the digits i changed. Ah well back to the drawing board, it seemed to simple!!

[mickyfinn]

zek, please check your pm.

[G77]

schweet! well done!

oh well, nevermind.