|
||||||||||
| Satellite Help Anything satellite related |
![]() |
|
|
LinkBack | Thread Tools |
|
|
#1 (permalink) |
|
Member
Join Date: Feb 2006
Posts: 86
Thanks: 1
Thanked 0 Times in 0 Posts
|
hi
I ve got a big 1.2 metre dish that I can move manually and a small 60 cm dish up on the wall I think my big dish is on 19e (astra 1 ) and my small dish is on 28e (astra2 eurobird 1 ) the small dish is getting bbc 1 itv etc qvc sky news at 501 etc ie the small dish is coming in thru a sky box the big dish is getting al jazera mdr zdf kika rbb luxe tv sat 1 pro sieben super rtl vox cnn euro news and tons of other stuff do you think Im right in the above ? |
|
|
|
|
|
#3 (permalink) |
|
Member
Join Date: Feb 2006
Posts: 86
Thanks: 1
Thanked 0 Times in 0 Posts
|
thanks
my problem is that many of the channels on the small dish are breaking up qvc etc, probably those on the weeaker satellites so I want to have a go at moving my big dish at 19 degrees round to 28 degrees is there any channel i can tune to on 19 degrees that will also pick up a chaannel on 28 ? say sky news or something ? or is there some channel no I can punch into my techmate box ? thanks for any comment |
|
|
|
|
|
#4 (permalink) |
|
Super Moderator
Join Date: Jun 2008
Location: Blackburn, UK
Posts: 2,600
Thanks: 300
Thanked 1,029 Times in 669 Posts
|
The chanels on 19 are completely seperate to 28. It could be that your small dish has moved out of alignment slightly. You could try giving it a nudge and see if you can improve the signal. Use services, system setup, signal test. Takes a few seconds to refresh though, so nudge it wait a min to see the effect. If not check the lnb and cable chances are water has got in there and is causing problems.
Rick |
|
|
|
|
|
#5 (permalink) |
|
Satellite mad
Join Date: Jul 2007
Location: Kent
Posts: 9,374
Thanks: 97
Thanked 1,981 Times in 1,603 Posts
|
Where are you located? You shouldn't be having problems on 28E with 60cm.
1.2m is a complete overkill for the UK. To adjust the dish, go to motorised settings, pick a transponder from 28E, and swivel the dish round and down a bit until you get good quality signal. Check that you get the correct channels. Use Lyngsat as a reference
__________________
القمر الصناعي هو أفضل TM600 linux,TM6800HD,TM5200,TM1000,TM2200 motor, Triax TD110 dish. Electronics Engineer and satellite installer.MBC Satellites
|
|
|
|
|
|
#6 (permalink) |
|
Nook in footer
Join Date: May 2006
Location: S. Yorks
Posts: 1,760
Thanks: 12
Thanked 129 Times in 108 Posts
|
Your 60cm dish has probably moved and just needs realigning. Just put it on QVC and try moving it a little to get a good picture.
No point in moving the other dish. Yorks
|
|
|
|
|
|
#7 (permalink) |
|
Member
Join Date: Feb 2006
Posts: 86
Thanks: 1
Thanked 0 Times in 0 Posts
|
thanks, I would nudge the dish, but for some insane reason
I had the guy put the small dish near the roof and I don t trust myself on ladders I should have told him to put it 5 feet up the wall so I could easily get at it ! My 1.2 meter dish however is sat on a slab of concrete, I can get at that and move it around from 19 degrees to 28 degrees east wot I wanted was advice onto which of my 19 degree channels to set it that might easily pick something up on 28 would you advise puttingi it on sky tv for eg ? I can turn the dish and hit the 28 degree satellite but if my techmate box is nt tuned to a channel up there... then nothings going to happen remember this big dish isnt motorized Im turning it manually ! there's also an annoying 1 or 2 second delay with digi before the channel kicks in with the old system ( pre digital ) the signals flashed up almost instantly ( as I looked thru the kitchen window to see a TV screen ) |
|
|
|
|
|
#8 (permalink) |
|
Satellite mad
Join Date: Jul 2007
Location: Kent
Posts: 9,374
Thanks: 97
Thanked 1,981 Times in 1,603 Posts
|
None of them, it doesn't work like that, it is digital. Monitor the signal quality while adjusting. 10773H for example.
__________________
القمر الصناعي هو أفضل TM600 linux,TM6800HD,TM5200,TM1000,TM2200 motor, Triax TD110 dish. Electronics Engineer and satellite installer.MBC Satellites
|
|
|
|
|
|
#9 (permalink) |
|
Super Moderator
Join Date: Jun 2008
Location: Blackburn, UK
Posts: 2,600
Thanks: 300
Thanked 1,029 Times in 669 Posts
|
As I said the chanels on each sat are seperate. You would have to align the dish to 28 and then scan in the chanels on your reciever. Your other option would be to add another LNB to the 1.2m dish then you can recieve both 19 and 28 without moving the dish.
Rick |
|
|
|
![]() |
| Bookmarks |
| Thread Tools | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| 2 motorised dishes - one receiver. | Yorks | Satellite Help | 12 | 11-07-09 05:05 PM |
| Darkman HD 2008 + Motorised Dish Set up | badgb21 | Satellite Help | 1 | 17-05-08 11:27 PM |
| the dish wont move remotely | flashgordon1952 | Satellite Help | 2 | 27-04-08 08:54 PM |
| how I set my dish up (long) | pete_l | Satellite Help | 3 | 30-03-08 11:48 PM |
| LinkBack |
LinkBack URL |
About LinkBacks |
| Bookmark & Share |
Digg this Thread! |
Add Thread to del.icio.us |
Bookmark in Technorati |
Tweet this thread |
