jtag the 2110c help needed please

[tec11]

hi

can i jtag my 2110c as i did with my 4000 to get the bk/ird numbers as im haveing probs using a unlooper then use a fun card for the netid then do a new fun card.


thanks

[morashid679]

No, You cant jtag the 2110, the only way to obtain the bk is by paired card.

What problems are you having?

Which script are you using?

Did you check the vcc of the card?

[tec11]

hi
im using winexplorer and sidewinder.
the card is a rom 11.
i dont have a clue were to start with the vcc settings i have the tuts but i just dont understand them lol.
thanks

[tec11]

Originally Posted by tec11

hi
im using winexplorer and sidewinder.
the card is a rom 11.
i dont have a clue were to start with the vcc settings i have the tuts but i just dont understand them lol.
thanks

Const VAVCCTestMax = &h30 '<--- Set this to the MAXIMUM VCC to test the card with.
Const VAVCCTestMin = &h8 '<--- Set this to the MINIMUM VCC to test the card with.
Const VATryLimit = 6 '<--- Set this to the NUMBER of times to glitch each VCC.
Const VADelay = &h1235 '<--- Set this to the DELAY to use for each glitch.
Const VAFFTgtPct = .6 '<--- Set this to the FF TARGET PERCENTAGE, i.e. the "sweet spot".
Const VAVCCSpread = 6 '<--- Set this to the SPREAD you want between VCCCeiling and VCCFloor.

do i change the settings in red ??

[morashid679]

Ok,
while the card is in the unlooper, run vcc analyzer.

DO NOT change anything in the script.

It will give you something like this,

XXXXXX----- 20
----XXXXXXX 19

and more numbers depending on your card.

Then at the bottom you floor to ceiling reading.

[tec11]

hi

this is what i get

VCC 30: --++++++++++ 6F = 83% FF = 17%
VCC 2F: ++++----++++ 6F = 67% FF = 33%
VCC 2E: --++++--++-- 6F = 50% FF = 50%
VCC 2D: ++++++++++-- 6F = 83% FF = 17%
VCC 2C: --++++--++++ 6F = 67% FF = 33%
VCC 2B: ++++----++++ 6F = 67% FF = 33%
VCC 2A: --------++XX 6F = 17% FF = 67%
VCC 29: --------++-- 6F = 17% FF = 83%
VCC 28: ++---------- 6F = 17% FF = 83%
VCC 27: ------------ 6F = 0% FF = 100%

VCC Ceiling: 2D
VCC Floor..: 27

[yusuf_gaz]

Hi

What rev is the card, rom 11 rev....

[tec11]

where do i find this ??
thanks

[yusuf_gaz]

Hi

When you try and read the card in nagra it should tell you, its most likely a rev bod alternatively you can just go ahead and try to unlock using either sidewinder or mikedata bod script. That setting in vcc looks should be ok without the need to adjust.

Regards

[tec11]

hi

running sidewinder now lets hope lol. how long does it take ????