TV drive help please

[bonez]

just been given a TV drive and card. ive read the card but cant get to fully read with Nagra or Winexplorer.

The error with Winexplorer is :
sc.read: timeout data from card - 112 bytes requested, 3 bytes read, continuing script.

script error on line 254
sc.getbyte: requested byte excee last read requested.



thats using various scripts for unlocking.


#

when using nagraedit, it errors with :

Rom rev : 011
EEprom revision : RevB0D
ect ect

using bd3 key : 4e 69 70 50 45 72 20 49 73 20 61 20 62 75 54 74
Attempting to login to BD3
Reading ROM11 failed
Close com4 was successful.


the card is the red type,with vermin on front.

Help would be much appreciated to get the IRD and K from this card please.



thanks

[G77]

try glitching with sidewinder with a vdc at about 25

[lambo]

it needs unlocking the rom11 bod script will do it

[bonez]

lambo and g77

thanks for your replies, ill have a go tomorrow now, i have shed loads of programmers , surely i wont need another piece of hardware yo unglitch ect.

if winexplorer and the script is used to glitch/unlock the card, whats the error that im getting?(above)

thanks again

Rich

[reddiesel]

Go into config in winex and increase rec time out, mike data script is the best for B0D.

[lambo]

the mike data script will change the ird the rom11 bod unlocker script wont, what unlooper are you using ?

[Tesla]

The error is most likely a Winexplorer setup problem, Configure tab, Program Parameters what does it have in there?

[bonez]

hi all again

basic idea is to get these BK and IRD keys out, but im still struggling, ive no unlooper as such, just a dynamite programmer.

Winex settings are:
Comm 4
Data Baud 115200
Reset Baud 9600
Parity none

Rec Timeout 3000
Byte Delay 700
Reset Delay 100
stop bits 1

Byte conversion Direct

Flush recieve buffer before writes


Are these correct?, if no, can someone help please

As for sidewinder, im new to this app, how do you increase VCC to 25volts??


Thanks

Rich

[Tesla]

I am always a bit dubious when it dosn't say com1, what is your set up ie programmer, laptop or pc, operating system and what port are you using usb or 9 pin rs3232 etc

[bonez]

Tesla, hi m8
im using USB RS232 i could set to Com 1 if need to, Win XP Pro, Laptop, programmer is the dynamite, but ive another phoenix if needed.


thanks for help


Rich