vcc Help

[opcbonas1234]

ive ran the vcc v2 script it says 40 vcc then it counts down with xxx then when gets to say 27 goes to ++++ then - at the end , how do i set it to 25 , when i load sidewinder i get port detected then loading 04 , no response ?

[G77]

your vcc is way out then. i'd say way to low.

now i know nothing about winx or scripts or vcc analyser because i had a go with it and secided that with sidewinder, winx wasnt for me.

if you have a locked card which isnt important (ie its not from a sa8300 or sam 2110) put it in the unlooper and turn the pot 1 quarter or a turn until you get sidewinder running ok.

when you've done this, leave it running and adjust your pot to that the VDC in sidewinder is right. 1a for rom 10's, 25-26ish for rom 11.

then leave the pot alone.you only really need to adjust it slightly when a new card is started. (because every card is different)

if you have been doing rom 11's and then go to a rom10, i'd say that its ok to start it off and start decreasing vdc straight away.

we'll prob get some other opintions on this. i'm just letting you know my experience with sidewinder and osc's.