Tiny unlooper prob

[aubrey4444]

right i run the WHATFLASH and this is what i get which i think is right


Reading data.
TX Data : 90
RX Data : 54 49 4E 59
Version Number returned from Atmel is : TINY
TX Data : 90
RX Data : 2D 4E 44 31 31 58 58 58 20 20 20 54 49 4E 59 What-Flash script has now
ended.

Script C:\Documents and Settings\phoebe sandison\Desktop\tiny
unlooper\What_Flash_V2.xvb Transmission Completed

then i try to run mikedata script and it says this

Card Didn't Response Correctly-Please Reset Your Dual Unlooper By The Reset
Button Before Starting The Script Again,Or Your Card May Be Looped-Check In
NagraEdit 4.1
Script Will Now Exit..Oh Deer

Script C:\Documents and Settings\phoebe sandison\Desktop\tiny unlooper\MIKEDATA
& CHARTMAN BOD SCRIPTJan 2008 .xvb Transmission Completed

and when i try to run vcc



Executing Script: C:\Documents and Settings\phoebe sandison\Desktop\tiny
unlooper\VCC Analyzer v3.xvb
TX Data : 02 03 00
TX Data : 02 02 00
TX Data : 07 0E 03 10 01 03 9A 00
RX Data : 02 00
TX Data : 12 15 AB 21 00 08 A0 CA 00 00 02 12 00 06 55 0E
03 8B 00
RX Data : 02 00

VCC 30: XX

Sc.Read: Timeout Reading Data From Card - 2 Bytes Requested, 0 Bytes Read,
Continuing Script

Script Error on Line 79
Sc.GetByte: Requested Byte Exceeds Last Read Request

anything i need to know ...PLEASE

thanks

[Danielle]

is it genric serial mate (from back of pc as it was bought) or some adaptor ?

[aubrey4444]

from back of pc to the tiny unlooper

[morashid679]

Check your card in Nagra or winxs.

If nothing check program parameters in winex.

rec timeout: 3000 data baud: 115200 byte delay: 100
reset baud: 115200 reset delay: 100 parity: none stop bits: 1
byte conversion : direct
and tick flush receive buffer before writes.

then save as my unlooper, but make sure you select which comport you have the unlooper connected to.

[morashid679]

When you run vcc, before you power up with the tiny writing the right way up turn the brass screw all the round clockwise till you can hear it click.

Then turn back very slowly 4-5 turns.

After that power up and insert the card and run vcc again.

Make sure you have a card which you want to check vcc for otherwise you will get all XXXXXX for the reading.

[aubrey4444]

thanks for all the help

cheers