plz help err 20

[bigjazza36]

hi there ppl could any1 help me with my pace box(ntl) model dl4001nc it was stuck on pace till i read to give it a clean witch i did now it just sticks on err 20 hope some1 can help cheers................bigjazza

[abaaba]

leave it on the stream for 30 minutes, remove any other connections/spliters. its signal problem i think.

[bigjazza36]

cheers m8 will give it a go

[blakey_8]

Here are some known error codes/meanings for ntl boxes:
Err1_ CRC fail across Primary Loader image.
Err2_ No longer used.
Err3_ Insufficient NVRAM
Err4_ Flash Fail or can't find platform object
Err5_ NVRAM not found
Err6_PSI buffer full download packet re-sizing required
Tuning Sequence Related Errors
Er10_ Unable to Tune to Last frequency
Er11_ Unable to Tune to Home Frequency
Er12_ Unable to Tune to any of the last NIT defined frequencies
Er13_ Unable to scan for a frequency
Er14_ Unable to scan for a symbol rate
Er16_ Unable to tune to hardcoded frequency
Input Stream Errors
Er20_ Timeout on receiving NIT
Er21_ Timeout on receiving PAT
Er22_ Timeout on receiving PMT
Er23_ Timeout on receiving object data
Er24_ Timeout on receiving TDT
Er25_ Sync loss has occurred on the input stream
Object Validation
Er30_ Object CRC Fail
Er31_ Object Digital Signature Fail
Flash programming errors.
Er40_ Insufficient Flash ( NAND Flash Specific )
ErrC_ Failed to Erase Flash Sector
ErrD_ Failed to Program a Flash sector.
ErrE_ CRC Failure of image just programmed into Flash

I highlighted your error code in bold. Try resetting the box (by pulling red jumper for 2 mins) and then re-setting the Net ID.