Samsung 2110c Net Id

[morgan]

Hi guys, Will be changing the 8 leg atmel chip this weekend on my 2110c to change the Net Id then i will make a Funcard 4 to reset it, what size chip do i need a 512 or 1024 ? Just to also confirm i need the box key to load to the Funcard as well..

Thanks again...

[Tee_111]

Originally Posted by morgan

Hi guys, Will be changing the 8 leg atmel chip this weekend on my 2110c to change the Net Id then i will make a Funcard 4 to reset it, what size chip do i need a 512 or 1024 ? Just to also confirm i need the box key to load to the Funcard as well..

Thanks again...

You dont need to lift any chip to replace net_is on a 2110.. use the funcard method to change net_id... works a treat..

[yusuf_gaz]

Hi

As said by Tee above dont need to lift anything, do the following.

Press standbye ok and < > as you are powering up till you see ld06 then once its finished go back into EM and check netid should show 09999.

If in pure netid will set itself and you would need to set freq and symb rate I think and the pin as well, if in area other than pure use the funcard method using netid 2.17.

Other than pure you can only set netid if you have the ird and bk for box using above method.

Regards

[morgan]

Thanks for the quick reply, do i still need to get the box key to load onto Funcard 4 Thanks...

[yusuf_gaz]

Hi

Without boxkey you aint gonna get anywhere.

Regards