250 modem

[sattelitesmania]

hello techwatch , i am kind of new to modems , so i hope you can help me out .

my 250 modem is flashed with haxorware , and i was wondering what is the next step to get it up and running ?

hope to hear from you all .

Sattelitesmania

[666]

type in haxoware and look for settings, i posted them some where

[sattelitesmania]

hello 666 , ok i will do that and get back to you .thanks for the reply i appreciate it.

[sattelitesmania]

i had a look 666 and can not seem to find it , can you explain the next step to me please

[lee-ds]

Settings-

General:

Factory Mode - Unticked
Disable Firmware Upgrades - Ticked
Force Network Access - Ticked
Tftp Enforce Bypass - (leave unticked for now) Ticked
Disable IP Filters on Startup - Unticked
Current IP Filters Status - Optimized

Administration:

Control Panel IP Address - 192.168.100.1
DHCP Server - Ticked
Telnet Server - Unticked
Username - Root
Password - Admin

Press Save

Frequency Settings:

Annex - Both
Plan - European
Preferred DS Freq 1 - 402750000 (this is for NTL) (TW are 331000000 or 339000000)C&W frequency - 586750000
2 and 3 -just enter 0
Upstream channel - dont change (will change on its own)

Press Save

Addresses:

HFC MAC - Your Mac Address
Ethernet Mac - Dont touch
USB MAC - Copy your HFC MAC address, only this time change the last letter/number on it to 1 letter/number higher.
Serial Number - Dont Touch

Press Save

Config File:

Server IP: (leave for now) Put whatever your server IP address you are using here, you can get it from DHCPforce.
Filename: (leave for now) Whastever you wish for your filename to use, if you want to force the 20mb option, then use - cmreg-ntlhm250-bund03.cm for NTL area, once again TW etc will be different.

Autoserve Enabled - Unticked
Stored cfg/store new config - no need to do anything here.

Press Save

Baseline Privacy:

BPI - Disabled
Certificate - BPI Public Key

All the rest in the Baseline privacy section will not be touched.

Press Save, basically press save in every page when ever you change settings otherwise they wont stick.

Original TUT by pokerplayer

[sattelitesmania]

thanks for that lee , where do i put input these settings , im sorry but im not clued up on modems at all , we all have to start somewhere


thanks for your help so far , i appreciate it , also would you mind telling me the next step after that .

[lee-ds]

Open up haxorware UI (*ttp://192.168.100.1)

start at settings and work your way down until all the instructions are complete.

[sattelitesmania]

thanks lee , i appreciate it.

[sattelitesmania]

ive sent you a pm lee

[sattelitesmania]

also what would be the next step after this .