Help with a 256

[namkrad]

hi guys maybe someone can help me with this issue before i desolder a chip.

I bought a spansion chip last week with haxo on it so i soldered it in and bingo works first time so i bought another standard modem and 4 more chips from the same supplier all pre programmed with haxo i soldered in the chip, and all i get is an exclamation mark on connectlivity so i tried reboot modem and windows still excalmation mark.

By the way the modem went to default config page with its standard chip in so it works ok anyway back to where im up too, i unsoldered the haxo chip and replaced it for another one still no joy all i get on power up is all lights flash then the power light stays on and the <...> light lights for 10 secs then goes out which i presume is the ethernet light.

Am i missing something as the first modem i ever tried worked flawlessy

[G77]

set the nic ip to 192.168.100.10 and go to the haxor page and reset factory settings. make sure dhcp server is ticked too

[namkrad]

thanks g77 where do i set the nics ip address

[G77]

search for it here, its widely covered for vista and xp

[namkrad]

i googled it and could only change the ipv4 address so i changed the ip
to 192.168.100.10
subnet mask 255.255.255.0 i dont know what to put it in the
default gateway i searched in advanced search been lokking since i made the thread earlier i still cant get anything but an exclamation mark is it the right subnet mask and do i need a default gateway.
Am i even doing it wright ? in the ipv4 sectin as i cant change it in the ipv6 section on vista