rom10

[silverpalm]

hello i have a tester box to play with a paired rom 10 card
i know i have to use a rom 10 script if i use winexplorer,but do i need to flash the unlooper again with say new10 or will the flash i put on the unlooper for the rom11 do that was new11x

or is it better to use sidewinder,and do rom10 card take longer i have been running say winexplorer for 20mins+ and sidewinder for a little less
i have tried to chnage the ohm screw on the unlooper but no joy
sory to keep asking i have been trying to sort for a few hours i just might have missed something being a noob
thank you

and should i invest in a ohm meter to set the best setting for each card type,
thank you

[silverpalm]

i think my unlooper is broke as sidewiner i cant get the vdc to green it only stays in the red,on matter which way i turn the little screw the little you turn it it possible to turn it so many times it looses setting or do i simply put back in the middle to reset what it came with thank you

[G77]

what voltage are you giving your unlooper?

[silverpalm]

hello im using a 9v should i try a higher v,i tried the unlooping with the dipswitch 2 on and 1 off and on sidewinder it is green with vdc a,b what are the rst10 rst8 ect mean
cheers mate

[G77]

powersync = 12v

rst10 = dont know, as long as vdc is 25ish for rom 11 and 19, 1a for rom 10, it will unlock it

[clarkyj]

i have a t911 unlooper and i done a rom 10 not so long ago you dont need to flash it again just a script that will do rom 10 ,s .. it does take a bit longer to unloop them though

[silverpalm]

think im gonna have to wait to get a ohm meter as i have messed with the little screw so often on all the dip switchs i ahve prob messed the settings up
if i have it on switch 1 and move the screw to the middle is that it back to the 2.2 it came set at on acording to the pcb board

thanks for all the helps

[silverpalm]

i think its the card after finaly getting between 19-a1 on the vdc part of sidewinder nothing happens just---++--rst19-----++++rst8 ect
i tried on winexplorer using script milk A86 AND BOD SCRIPT MAY 2007 A86 no joy the card chip smells burnt so i think its a gonna

[G77]

Originally Posted by silverpalm

i think its the card after finaly getting between 19-a1 on the vdc part of sidewinder nothing happens just---++--rst19-----++++rst8 ect
i tried on winexplorer using script milk A86 AND BOD SCRIPT MAY 2007 A86 no joy the card chip smells burnt so i think its a gonna

thats right. thats what your after. let it run overnight.

you could try winex asnd that a86 script. it might be quicker

[silverpalm]

hello mate
so im doing it right buts just thats its gonna take a very long time todo
on winex is it all right it going from 19 to 1c doing i have to keep sorting it back to 19-1a
cheers mate