changing net id for sa4200

[shaks08]

Hi guys, can i use the fun card method to change the net id for sa4200, and how can reset the box before i can change, like you need to pull red jumper for pace boxes,

[tdubman]

ive only been able to change the net with an atmega on that model //but give a fun card a go mate

[shaks08]

iv managed to take the u2007 chip out and iv also got a willem programmer to blank the chip, but i cant find anywhere to sit the chip on the programmer, do i need an adaptor or am i missing something.

[tdubman]

you can solder wires to the legs and then into the progger

[shaks08]

thanks tdubman, but whereabouts in the progger do i solder the wire, any pic of it

[G77]

on the willem you would solder it into the socket marked 24C**

there is a row of 3 sockets with no chip in, its the one at the top if you have the parallel port on the left

[tdubman]

nice1 g77 i have a scotch clip just clips on the chip legs other end goes in the proger //but mines a labtool dont do willems or elvis //

[shaks08]

thanks g77, but i dont think iv got that socket , i cant find 24c** anywhere on the willem, it was purchased from jabs place and iv noticed there are different types of willem proggers.

[G77]

have you got a picture of it?

[shaks08]

iv no picture but here's the link where i bought it from and has exact same picture of the willem