Arnet A700C glitches

[subeng8]

Hi i have a Kyrptview Arnet A700C and intially after setting it up and searching for channels in my area all was good end of last year.

Now though more and more channels are either freezing up and going 'blocky' or are being scrambled and the Arnet box struggles to decode them.

Software version is pv1.9.50
Hardware version is 1.2.0

Anyone got any suggestions as to cure this?

Thanks in advance

[Cyclone]

Started getting this myself a few weeks ago.All I did was go into the system settings & adjust the signal devaition.I've currently got mine set on -3 and it has cured the syptoms that you described.
Hope this helps you & I'm amazed that nobody else has replied to your cry for help.

[WORZEL]

Originally Posted by Cyclone

Started getting this myself a few weeks ago.All I did was go into the system settings & adjust the signal devaition.I've currently got mine set on -3 and it has cured the syptoms that you described.
Hope this helps you & I'm amazed that nobody else has replied to your cry for help.

Tried the above for a few weeks now but to no avail, still freezing and blocking every 30-40 seconds.
Is it time for a new box?

[yusuf_gaz]

Hi

Try connecting the cable to the cable output of box and see if it improves it.

Regards

[WORZEL]

Originally Posted by yusuf_gaz

Hi

Try connecting the cable to the cable output of box and see if it improves it.

Regards

Have a eurovox 1000sl on the cable from the output of the arnet and has no problems at all.

I may have solved the issue with the freezing and blockyness.
factory resetted, downloaded transponders, was using Basildon RE3. have now changed it to Basildon trialist SE01. works a treat however still needed to attenuate the signal down to -3.
Still thinking of getting the Eurovox 7000HD though.

Regards
Worzel