just flashed webby using (Using Full Dumps to Load Haxorware Firmware)

[tommy2426]

Hi folks, got so far using a tut i got and everything seemed to be going great until the last part
ie Board TFTP Server IP Address [0.0.0.0]: 192.168.100.10 (press enter)
Enter TFTP filename []: haxorware_full2mb_dump.bin (press enter)

although i used the "haxorware11rev30.rar" instead of the 1 above, when i hit the last enter this is the readout i got, but it doesnt compare to the 1 in the tut and im wondering if anyone can tell me what this readout means, first time flashing so im a bit of a newbie, cheers

.................Tftp complete
received
image
signature
major
minor
build
file.
load.
Warning signatures do not match. Dont use this image.
CRC verified
Destination image
0 bootloader
1/2 CM image
3 specify flash sector.


im sitting with this loaded in hyperterminal and dont know where to go with it next, anty help much appreciated, cheer

[50pounds]

try another 1 its not bricked by the way..

haxorware help

have alook here for a .doc that gives you pictures mate.

[sr20]

Originally Posted by 50pounds

try another 1 its not bricked by the way..

haxorware help

have alook here for a .doc that gives you pictures mate.

not bricked yet anyway lol

flash 2mb dumps to '0', single images to '1'

sr20

[lee-ds]

Originally Posted by tommy2426

Hi folks, got so far using a tut i got and everything seemed to be going great until the last part
ie Board TFTP Server IP Address [0.0.0.0]: 192.168.100.10 (press enter)
Enter TFTP filename []: haxorware_full2mb_dump.bin (press enter)

although i used the "haxorware11rev30.rar" instead of the 1 above, when i hit the last enter this is the readout i got, but it doesnt compare to the 1 in the tut and im wondering if anyone can tell me what this readout means, first time flashing so im a bit of a newbie, cheers

.................Tftp complete
received
image
signature
major
minor
build
file.
load.
Warning signatures do not match. Dont use this image.
CRC verified
Destination image
0 bootloader
1/2 CM image
3 specify flash sector.


im sitting with this loaded in hyperterminal and dont know where to go with it next, anty help much appreciated, cheer

Unzip the bin file first mate.

[tommy2426]

Originally Posted by lee-ds

Unzip the bin file first mate.

I just copied and pasted that "haxorware11rev30.rar" quote m8, i have unziped it to the folder but that firmware did not take either, i did manage however to put this on "ntl250-sb5101_hack" without any problem, thing is i followed the haroxware tut, then all of a sudden my IP had problems and i have just managed to get online, so now i have a modem flashed with said firmware and i dont know where i should go from here, is there a tut that i could use from this stage, im so close and dont want to mess it up, cheers