Eurovox max v blue problem...

[seano157]

Hi all, wondered if anyonre colud help me?

I have the box as mentioned in thread. I unplugged it to move it, only when I plugged it back in the screen says '0196' and wont move.

Any ideas peeps?

regards

seano157

[bkuser]

this is a few remedies for your problem it sounds like a blue clone so try to get it flashed with clonesafe firmware once you get back to screen



plug in as normal, cable feed, power, but instead of using
the scart, use an aerial( analogue ) the old fashioned way of connecting them to the
television, you should use the channel search on your tele to find the box, once you have
found the box go to the menu 1004 for the code, tv settings,
MULTI,
4.3
RGB
FULL FRAME
ON
PAL B/G
40
save and exit
now unplug aerial, reattach scart and hopefully you've sussed it, remember the aerial goes
into the tv vcr socket not the one below your cable feed. cable feed should be in as well
go to factory default, powerscan, and hope all is well.
unfortunatley you'll have to wait for a new flash but at least your up and going and your
box isn't bricked.


this is the sequence to do a factory default reset on your box without being able to see whats happening on the TV screen.
with your box connected to TV as normal
switch your box on and make sure you point the control at the box
very carefully enter the following sequence
1004
menu
right,right,right (arrow keys)
down,down (arrow keys)
OK
1004
down
OK,OK,OK
wait a few minutes whilst box resets itself and hopefully you will get a distorted picture showing that your scart is working again.
then reflash with the correct firmware