When trying to flash Eurovox 2 DnupMan can find any ports.

[Stabber]

My box would not pick up any channels after a power scan. I then made sure the keys were up to date and tried an auto scan which never worked. Next i returned to box back to factory settings and put in the up to date keys and ran an auto scan which gave me a limited number of channels. Then tried a power scan which failed once more. I then followed the instructions to the letter for flashing my box but Dnupman wont pick up any of the ports. I have made sure the ports are enabled and the drivers are up too date and still no luck. I have also tried it in boot mode and had no luck either... If anyone out there can help it would be very much appreciated...

[abbs2002]

This is how to do it m8, check to see if you are making any mistakes;

Clone eurovox max and eurovox 1 + 2


This is the old Dnupman way of flashing and should now only be used on clone eurovox max and eurovox 1 + 2

1.connect your box to pc and power up (your pc wont detect the box yet)
2.open Dnupman
3.click on browse and locate your firmware
4.click on download and Dnupman will start checking your com ports for a eurovox
5.when its found your box click start to send the firmware
6.it should now start downloading and should take approx 3 mins to flash
7.when download is finished it might say download failed but should jump to download successfull straight away.
That’s it done! Any problems I will try to help you with but you won’t (shouldn’t) have any!!
Good Luck...