Need u2007 chip for 4200

[yusuf_gaz]

Hi

I think to write to the chip its going to cost you £15-£18 for the proggy.

Its showing 09999 because you have put a new blank chip in, have you tried resetting netid using funcard method.... Not sure if you can use that method on your box.

Regards

[G77]

atmega card is best

[G77]

here you go mate.... the bit of the socket which looks like the goal area on a footie pitch is the end were the dot on the chip goes.

if you load your willem software, and select 512 (128) it shows you where to put the chip and what dip config to use.....

but, just in case, the dips go all off and the chip goes here.....(green board = willem 5, brown board = willem 4.5).......

[sunlight786]

i have
Willem Programmer 4.5 withTSOP48

[G77]

pics a bit small but i cant see any empty sockets on that one

[sunlight786]

ihave order this one from flebay .is that ok?

24Cxx, 93Cxx and 25xxx Serial Eeprom programmer E-EPROM

[G77]

could you not just of got a blank chip?

whats the ebay number for the progger you got?

[G77]

seen it now, looks like it will do the job.

you'll need to get ponyprog like it says in the manual.

you'll also still need to solder the chip in with wires.