sammy bytes..2100c help

[Nivida]

hi im using BKE2.2, & the 0x00895934 8 ,,without the 8. is this right as i seem to b getting differnt bk's back .......with mostly all FFFFFFFF, ???? help plz thanks

[Shark.]

Have you got mac_mot running ?

And have no solder bridges between the points etc. and have p&p legacy enabled in printer port properties.

Shark.

[Nivida]

yes m8 i have mac not running ,, i checked in enj menu & SW was 3_6 But the box has been of 4 a while, so would u let it updaye first then try again!!!!!! + does it have to be in debug mode while im j-taging it


(tryed > 0x00895934 8, byte without the 8 .& still getting mostly fffffff's thanks)

[Shark.]

It shouldnt matter if it's on the latest software aslong as you have the bytes for the current software.

I usually have FFF's when i havnt soldered the points well enough...

I dont think samsungs have to be in debug mode . . ive jtagged every one of mine on-stream on channel 999.

Hope this helps.

Shark.

[Nivida]

ok @ shark thanks ..i will double check iv got the right bytes "
0x00895934 " pure 3_6, iv tryed it a few times 2 night but keeps giveing me a funny looking BK number ** **FE FF FF FF FF, thee 1st arnt fff's but it dosent lokk right to me but not trye ivd it yet!!!,, & its a pogo j-tag so havent got 2 solder! mybe it not conecting right ??? its gives me the same IRD every time ..wich seems strange its pickibg the ird up but not the bk .....thanks 4 helping m8

[Nivida]

hi just seen a pic of were the pins connect , mine uses ..nunmbers 2,5,7,9,13 & 20 ,, but in the pic its not the pin is on number 16 & not 20 ????? dont say i have a doggy j-atg ..can some1 make sure im right & have the right pins in place ..i got it .from tcm

[Shark.]

Hi mate just match the 3 letters on the curcuit to the correct pin in this layout.

Pin 2 -- 3.3v

Pins 4-20 -- 0v

Pin 5 --TDI

Pin 7--TMS

Pin 9--TCK

Pin 13--TDO

Shark.

[Nivida]

yes ok m8 done that !!! but still the same ..might use another poroggy, or try instaliing it again ..4 saome rearon its not picking the bk up

[thedogsballs]

Originally Posted by Nivida

yes ok m8 done that !!! but still the same ..might use another poroggy, or try instaliing it again ..4 saome rearon its not picking the bk up

Hi m8 was doing the same yesterday myself ,,put the box in debug mode first this is the old way of doing these boxes but how i was able to get mine done yesterday,,keep cable feeds in and make sure you have updated the firmware to 3.6 ,,

[Nivida]

Originally Posted by thedogsballs

Hi m8 was doing the same yesterday myself ,,put the box in debug mode first this is the old way of doing these boxes but how i was able to get mine done yesterday,,keep cable feeds in and make sure you have updated the firmware to 3.6 ,,

yes m8 iv done it .whoooo.. i updated it let the number roll. turned off. took the feed OUT ..put in debug mode & the bk came up no probs ...................................so it looks like they have to be in debug mode ! thanks every1 4 helping me out