ohm set-up on unlooper b4 flashing

[kkd]

Originally Posted by blakey_8

Yes, the two wires are what you need. Set the multimeter to 2K Ohms, put the two wires in the hole and then you should get a reading. DO NOT do this with anything plugged in, not even a card. I know I said this before but if you don't take note, you will damage the unlooper!

Hi blakey, I did setting resistors on unlooper but got readings like 1191 kilohms (1.19kohms) will it be ok. When I swap probes on test points, it read diferent.1.45kohms).

[kkd]

Originally Posted by reddiesel

DX11 is the flash for the unlooper it should already be flashed you dont use winex for that, run vcc analyser in winex to set vcc although that should be set near enough also, in your copy of winex click on config and set for my unlooper it should be in the config files, try mike data script for the rom 11.

Yeah got it but why cant I open xatmel 2.0 exe to flash my onlooper. Getting mesaage that is not last file in archive so wouldnt open

[blakey_8]

Open the archive and extract manually mate. I had to do this as well, I don't know what the problem is.

[kkd]

Hi blakey do you have any comment on my multimetre readings above?.

[blakey_8]

I'm not sure, I had it bang on with my multimeter using 2k.