sammy help pleeeeze

[rickster1]

hi im trying to jtag a sammy when i connect it keeps saying target communications error unable to put target into background mode what does this mean any pointers would be great

[MaD_FOr_iT]

check your wires and make sure u run mac mot driver

[rickster1]

mac mot running m8 getting shocks so wires must be fine do u know if these are rite bytes for pure 0x20020004 0x00895934

[rickster1]

just notices the power button on box is on red ld20 what should it be

[chris31560]

hi m8 ld20 is wot the box should be sayin until the feed goes id then it should say ld30/40 then numbers roll and it should end on ap53 then channels should come on..

[MaD_FOr_iT]

sry i dont know the bytes for pure 3.7 but check the ird if thats shows u know its workin then it a case of finding the pure bytes

[gondazilla]

ok thought id lend a hand to all them having an issue with this im in the middle of pure and had this problem were ive been getting 0000000000 box key so after playing around i found that the followg works perfectly worked on 2 boxes

1 installed std and motd running
2 put box in and online well holding jtag inplace
3 put 0x009285CC into std with 15 bytes
4 hit read on std when box was on ap:53
5 gives me loads of numbers

first 16 are the box key and hey presto

before this was gettting all 200020002000200020002000200020
after it hits channel 101 all was getting was 200020002000200020002000200020

hope this helps