NagraEdit

[godlike007]

I am using NagraEdit to read from the card. The usb lead is working ok, When I try to open up the card this is what I get: Opening of COM4 was successful
Reset failed Error reseting card, ATR string invalid
Closing of COM4 was successful
I get this using any of the ports. The software is set up to com port 1 with high speed pci port 3 can any one help me with this.

[reddiesel]

Originally Posted by godlike007

I am using NagraEdit to read from the card. The usb lead is working ok, When I try to open up the card this is what I get: Opening of COM4 was successful
Reset failed Error reseting card, ATR string invalid
Closing of COM4 was successful
I get this using any of the ports. The software is set up to com port 1 with high speed pci port 3 can any one help me with this.

You need to sort out the right com port you have nagra set to 4 although its opening successfully, set everything to the same one, you dont say what programmer your using is it a phoenix with a com port and usb or an unlimited with virtual com port ?

[godlike007]

Originally Posted by reddiesel

You need to sort out the right com port you have nagra set to 4 although its opening successfully, set everything to the same one, you dont say what programmer your using is it a phoenix with a com port and usb or an unlimited with virtual com port ?

its a phoenix with a com port and usb, only I am using a pci card with 2 comports on it. I have looked at the com ports but everone I try keeps saying the same thing. I am new at this. when I use infinty usb software it will find and read the card, its just I cannot get it to read from nagraed?

thanks

[reddiesel]

Originally Posted by godlike007

its a phoenix with a com port and usb, only I am using a pci card with 2 comports on it. I have looked at the com ports but everone I try keeps saying the same thing. I am new at this. when I use infinty usb software it will find and read the card, its just I cannot get it to read from nagraed?

thanks

Have you got the programmer in phoenix mode 3.68 ?
Go into device manager and click on the com ports card and check that drivers are enabled and ports are working,and make sure you set the correct port you are connecting to in nagra edit by clicking on options then communications.
If everything is ok then the card is dead.