How to get MM into MR ? and Get it back to MM again !

Ragabbader · 21-08-06, 04:04 PM

How to get MM into MR ? and Get it back to MM again !

I'd like to provide the files and steps needed to convert your MM to MR or MR to MM

First , Converting MM to MR

You need Cas Interface 2 or 3

Open Cas Interface Studio :

1- Click on Matrix Reloaded
2- Insert your CAM (the Cas should reconize it) , then press Erase All
3- After Erasing the flash , Click Open File , Select MR1.XXX File.
4- Press Write
5- After writing the MR file , Write "Matrix.cas" in Xlinx.

That's all , Now you have your MM in MR

Converting MR to MM:

You need Cas Interface 2 or 3

Open Cas Interface Studio :

1- Click on Magic Module
2- Insert your CAM (the Cas should reconize it) , then press Erase All
3- After Erasing the flash , Click Open File , Select Dreamload.bin file , this file is important to get your cam in loader status , you will find many files , just take the file that fits your cam flash for example (Toshiba) is the flash of your MM , so choose Dreamload_Toshiba.bin file , and others in the same way
4- Press Write ,
5- After writing the MR file , Click open again and wrtie MM bin file (Pentacrypt 111) for example , before doing this go to Advanced Option and get start address to 10000 , Now back to General , Write MM penta file , after writing it , go to Xlink and choose Magic.cas file , write it

Now your CAM is MM

Needed files are in the files section / Matrix Files
http://www.ragabbader.org/forum/show...9361#post39361

Cheers:wink_smile:

21-08-06, 04:04 PM	#1 (permalink)
Ragabbader Senior Member Join Date: Jan 2006 Posts: 3,761	How to get MM into MR ? and Get it back to MM again ! How to get MM into MR ? and Get it back to MM again ! I'd like to provide the files and steps needed to convert your MM to MR or MR to MM First , Converting MM to MR You need Cas Interface 2 or 3 Open Cas Interface Studio : 1- Click on Matrix Reloaded 2- Insert your CAM (the Cas should reconize it) , then press Erase All 3- After Erasing the flash , Click Open File , Select MR1.XXX File. 4- Press Write 5- After writing the MR file , Write "Matrix.cas" in Xlinx. That's all , Now you have your MM in MR Converting MR to MM: You need Cas Interface 2 or 3 Open Cas Interface Studio : 1- Click on Magic Module 2- Insert your CAM (the Cas should reconize it) , then press Erase All 3- After Erasing the flash , Click Open File , Select Dreamload.bin file , this file is important to get your cam in loader status , you will find many files , just take the file that fits your cam flash for example (Toshiba) is the flash of your MM , so choose Dreamload_Toshiba.bin file , and others in the same way 4- Press Write , 5- After writing the MR file , Click open again and wrtie MM bin file (Pentacrypt 111) for example , before doing this go to Advanced Option and get start address to 10000 , Now back to General , Write MM penta file , after writing it , go to Xlink and choose Magic.cas file , write it Now your CAM is MM Needed files are in the files section / Matrix Files http://www.ragabbader.org/forum/show...9361#post39361 Cheers:wink_smile: