Re: 195 patch

[silverhair]

Hi Guy's , Have C-Tech 2100 and just loaded latest patch. When I go to 10873 hotbird to au ,my receiver locks up and is caught in a loop of constant reboot. Have reloaded software and followed instructions re power off on channell and wait 20 sec. After 15 miniutes it was still the same (ie caught in loop) only way out was to disconnect from dish then change to fta channell reconnect dish and reboot. This restored all other functions on receiver and cleared au on other sats. It only happen's when trying to au TPS, all other's are fine. Has anyone else had a similar problem. Specs:sad_smile:

[parad0x_i]

Originally Posted by specs

Hi Guy's , Have C-Tech 2100 and just loaded latest patch. When I go to 10873 hotbird to au ,my receiver locks up and is caught in a loop of constant reboot. Have reloaded software and followed instructions re power off on channell and wait 20 sec. After 15 miniutes it was still the same (ie caught in loop) only way out was to disconnect from dish then change to fta channell reconnect dish and reboot. This restored all other functions on receiver and cleared au on other sats. It only happen's when trying to au TPS, all other's are fine. Has anyone else had a similar problem. Specs:sad_smile:

Hi specs..

Don't worry too much about this.. it wont harm your receiver we hope but yes it's a problem now with the new firmware and i hope yabbervox can find a workaround for it soon

AU was actually working fine.. and then suddenly wasn't.. so i think it is something Tps has done rather than the software..

To exit the loop...

..after the box reboots.. press the remote to select another satellite.. then move say to Astra then back.. and immediately change channel away from France channels 2 to 5 & O..

I have actually reloaded 194 and use plugdvb and the tps.bin.. until it's fixed..

:wink_smile:

[silverhair]

Originally Posted by Parad0x_i

Hi specs..

Don't worry too much about this.. it wont harm your receiver we hope but yes it's a problem now with the new firmware and i hope yabbervox can find a workaround for it soon

AU was actually working fine.. and then suddenly wasn't.. so i think it is something Tps has done rather than the software..

To exit the loop...

..after the box reboots.. press the remote to select another satellite.. then move say to Astra then back.. and immediately change channel away from France channels 2 to 5 & O..

I have actually reloaded 194 and use plugdvb and the tps.bin.. until it's fixed..

:wink_smile:

Thanks paradOx glad to hear it's not something I did wrong, will try plugdvd with 194p. Thanks again specs