TM 6000 HD Super 7.00p

[JGruuthuse]

Warning when you upload this patch you can not go back to older patches with the USB stick!
- Card+, no longer there
- CAS menu not stable

patch 7.00p for TM-6900HD Super and TM-6800HD Super <= click here
Thanks to Magic and Technomate

This is a 2 part patch:
1st load the Magicpatch
2nd load the ADDON patch

has a New Bootloader and some more goodies:
7.00 Boatloader 3.00



8 2 8 1 c c c a m

[spuk]

I see on the photos 1 newcamd line can only connetct to 1 port? so it is only possible to connect to max 8 newcamd ports? what if i want to connect to more than 8 ports, for example port 10000 to 10020? is it not possible with the technomate?:cry_smile:

[JGruuthuse]

you can take the TM back to previous patches before 7.00p, you need the Go Back patches either for TM 6800 HD Super or TM 6900 HD Super these are both different:
Don't use these with the USB stick you have to use the null modem cable

[JGruuthuse]

Originally Posted by spuk

I see on the photos 1 newcamd line can only connetct to 1 port? so it is only possible to connect to max 8 newcamd ports? what if i want to connect to more than 8 ports, for example port 10000 to 10020? is it not possible with the technomate?:cry_smile:

each port used = newline. there more servers possible, in newcamd: 1 port = nds, next port seca, ... Hard to have a range of ports as each port has other emulation.

[^^COMPASS^^]

Originally Posted by JGruuthuse

Warning don't take the patch back to older versions. My TM-6900 is out of order and needs repairing. when you go to 7.00p you can't go back to patch lower then 7.00p.

Can you not do a

FORCED DOWNLOAD INSTRUCTIONS

You will need to have your receiver connected to your PC via a Null modem cable!

These general instructions can also be used on the 5000 and 6000 range of technomates as well as the 1000 range
just make sure you use the correct latest working patch for your model number
and also make sure you are using darkman loader v1.87 and not an older loader


turn the receiver off at the rear mains switch and re-load the latest working patch, or use the technomate firmware if necessary

and when the darkman v1.87 loader asks connect to receiver turn it back on at the rear

turning the receiver on at the rear will force the download and clear the problem caused by any incomplete or faulty patches

after it has completed , reboot the box by turning it off and on again at the rear mains switch ( power cycle the box )

the box should boot and work normally

sometimes you may have to remove the lnb cable when the box is off , just to stop it looking for channels , reconnect this after the box has been restored but turn it off beforehand

now switch it back on and test

Regards...